Procedure; How To Use The Electronic Digital Indicator; Battery Installation Method; Troubleshooting Methods - Cojali jaltest Guia De Inicio Rapido

2 Procedure

2.1 HOW TO USE THE ELECTRONIC DIGITAL
INDICATOR
a.
Wipe the measuring rod and measuring head clean.
b.
Press the power button to turn on the power. Make the measuring head touch the
measured workpiece it by about 0.15 mm, then press the zero key to set to zero, and
the normal reading can be obtained.

2.2 BATTERY INSTALLATION METHOD

a.
Unplug the battery snap ring.
b.
Take out the battery.
c.
Replace the old battery.
d.
Insert the battery snap ring into the indicator (positive side facing up).

2.3 TROUBLESHOOTING METHODS

Phenomenon
Digital display flashes
Do not show anything
1. The displayed number
remains unchanged
2. Show that all specific
characters appear at the
same time (such as H, INC)
Reason
The battery voltage is low
1. The battery voltage is low
2. Poor battery contact
Accidental circuit failure
6
EN
Elimination Method
Replace the battery
1. Replace with new
batteries
2. Clean the battery
contacts
Remove the battery and
place it again after one
minute