Safety Information - Project Source 16438-003 Guia De Inicio Rapido

SAFETY INFORMATION

CAUTION
• For use with "hbt" series track only.
• Before starting the installation, disconnect the power by turning off the circuit breaker or by
removing the appropriate fuse at the fuse box. Turning the power off using the light switch is not
sufficient to prevent electrical shock.
• Do not exceed recommended wattage.
• Save these instructions and refer to them when additions or changes to the track configuration
are made.
• To avoid risk of electric shock or fire, do not modify this lamp; if any modification is made it may
render the product unsafe.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 5 ~ 6 minutes.
Tools Required for Assembly (not included): Ladder, Safety Goggles
ASSEMBLY INSTRUCTIONS
1. Identify ground side on track head assembly (A) and
track section (not included). Insert track head assembly
(A) connector into track section and twist to secure.
Make sure the ground side on track head assembly (A)
connector aligns with ground side of track section.
See Fig. 1.
Note: The ground side of track head assembly (A)
connector is the side with the two metal tabs. The
ground side of the track section has an indented
groove on the face and two internal copper bars.
The track head assembly (A) can only be assembled
if the ground sides are aligned.
2. Attach the suction cup (AA) to the bulb (B), and
secure the bulb (B) to the socket on track head
assembly (A) by twisting and locking correctly. Detach
the suction cup (AA) from the bulb (B) by pulling the
small pin. See Fig. 2.
Hardware Used
AA Suction Cup
1
2
AA
x1
3
GROUND
SIDE GROOVE
IDENTATION
A
B
A
GROUND
TAB
A
Lowes.com