Using The Sleep Timer; Using The Alarm; Setting The Alarm - Panasonic RC-DC1 Instrucciones De Funcionamiento

Memory preset
You may store your favourite channels in 5 FM preset channels.
Preparation
Press [SOURCE] to select "RADIO FM".
Automatic presetting (AP)
Press and hold [SOURCE] until "AP" is displayed.
Note:
• Automatic presetting begins from the current frequency.
• Only the fi rst 5 stations detected will be stored.
• "AP" will blink continuously until all 5 channels have been set.
Manual presetting
1
Press [2/–, ADJ] or [+/6, ADJ] to select the desired
frequency.
2
Press and hold [SET/PRESET] for 2 seconds to display
the preset number.
3
Press [2/–, ADJ] or [+/6, ADJ] to select a preset
number.
4
Press [SET/PRESET] again to confi rm.
Tuning in to a preset channel
Press [SET/PRESET] to switch between preset channels.

Using the sleep timer

This function enables you to turn off the unit automatically after
the set time (only in iPod and radio mode).
1
Press [SLEEP] to activate the timer.
2
Press [SLEEP] again to select your desired time
(in minutes).
OFF (default) ] 30 ] 60 ] 90 ] 120
Note:
Press [SLEEP] once to check the remaining time.

Using the alarm

You can set two different alarm times. Before setting the alarm,
make sure to set the clock (Z page 9, "Setting the clock").

Setting the alarm

1
Press and hold [ALARM 1] or [ALARM 2] until the hour
display blinks.
2
Within 10 seconds, press [2/–, ADJ] or [+/6, ADJ]
to set the hour.
3
Press [ALARM 1] or [ALARM 2] to confi rm.
4
Repeat steps 2 and 3 to set the minutes.
5
Press [2/–, ADJ] or [+/6, ADJ] to select the days
of the week:
MON-SUN (everyday) ] MON-FRI (weekdays)
SAT-SUN (weekend) SAT-SUN (weekend)
6
Press [ALARM 1] or [ALARM 2] to confi rm.
7
Press [2/–, ADJ] or [+/6, ADJ] to select the desired
alarm mode: "IPOD", "RADIO" or "BUZZER".
8
Press [ALARM 1] or [ALARM 2] to confi rm.
"IPOD" selection: Continue with steps 9 and 10.
"RADIO" selection: Continue from steps 11 to 14.
Setting iPod alarm
9
Press [2/–, ADJ] or [+/6, ADJ] to adjust the
volume level.
10
Press [ALARM 1] or [ALARM 2] to confi rm the setting.
Note:
• The buzzer will sound if no iPod or iPhone is detected at the
set alarm time.
• Music will be played from the iPod or iPhone's library when
the alarm sounds.
11 11
(Continued on next page)
11