Operation
1
Flushing and checking for leaks
□
Ensure the faucet handle are in the off position
and turn on the water supply to check for leaks.
If you discover any leaks, check your connections
to ensure they are installed properly.
□
Turn on the hot and cold handle to allow the
water to run for at least one minute. This
ushes away any debris that could cause
damage to internal parts.
□
Turn off the water.
Care and Cleaning
□
To clean, wipe down with a damp cloth and dry with a towel.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
Troubleshooting
NOTE: Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
Problem
There are leaks from the
handle.
The water will not shut off
completely.
Possible Cause
The handle has come loose.
The cartridge is dirty or broken.
□
□
□
6
Solution
Tighten the handle.
Remove the handle to check
the cartridge.
Clean or replace.