Urmet 1092/255H Guía Rápida página 5

ENGLISH
INSTALLATION
1. Before installation, make sure that all devices to be connected are not powered.
2. Place the bracket base on the supporting surface to mark the 4 fixing holes. Consider the position of
the slot placed on the bracket, used for the passage of the cable (see photo). Use the base as drilling
template.
3. Fix the camera and the provided suitable spanner, taking care to place the cable on the seat present
in the bracket, in order to avoid pinching the cable.
4. Place the bracket in a position suitable for shooting the selected images; the camera can be adjusted
on the HORIZONTAL and VERTICAL axis.
HORIZONTAL AND VERTICAL ADJUSTMENT

Loosen the ring on the bracket and the adjusting screw shown in the figure.

Point the camera at the desired position

Once the adjustment has been performed, tighten the screw with the grub screw and the
suitable spanner
Important! Don't use the screw placed on the other side of the camera
5. Connect the video output to the selected terminal device.
6. Power the camera.
7. Unscrew the screw on the bottom of the camera to access to the adjustment screws and to the OSD
menu button.
8. Perform Zoom and Focus adjustment for the desired image as follows

Use the trimmer Z to regulate the Zoom function on the image

Use the trimmer F to regulate the Focus function on the image

Use the button to select the video output (see below)

Hold down the button centrally to access the OSD menu
TO SELECT THE VIDEO OUTPUT
The 1092/255H camera may use 3 different video outputs, which are on the same BNC connector:
DS1092-216A
ADJUSTING SCREW
Button to access video selections and
the OSD menu
Trimmer to regulate Focus and Zoom
and relative lock/unlock screw
5