Stadler Form Robert Manual De Instrucciones página 6

• Do not use damaged extension cords.
• Do not run the power cord over sharp edges and make sure that it does
not get trapped.
• Do not pull the plug from the socket with wet hands or by holding on to
the power cord.
• Do not use the appliance in immediate vicinity of a bath tub, a shower or a
swimming pool (observe a minimum distance of 3 m). Place the appliance
such that a person in the bath tub cannot touch the appliance.
• Do not place the appliance near a heat source. Do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
• See to it that the appliance is properly positioned to ensure a high stabil-
ity during its operation and make sure that no one can trip over the power
cord.
• The appliance is not splash-proof.
• For indoor use only.
• Do not store the appliance outdoors.
• Store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
• If the power cord is damaged, it must be replaced by the manufacturer
or a repair shop authorized by the manufacturer or by similarly qualified
persons in order to avoid a hazard.
• Prior to any maintenance, cleaning and after each use, switch off the ap-
pliance and unplug the mains cable from the socket.
Setting up / Operation
1. Place Robert at the desired position on a flat surface. Connect the mains
cable (3) to a suitable plug socket.
2. Remove the water tank (5) by holding it by the handle and gently pulling
it back. Screw off the water tank lid (6) and fill the water tank with clean,
cold tap water. Then screw the lid back onto the water tank. Place the
water tank on the water tray (2). The water tray now fills slowly with the
water from the water tank. Important: please do not transport Robert as
long as he is filled with water. The water could spill over.
3. To switch Robert on, press the On/Off switch (4). The current relative
humidity is shown in the display in % («Air Humidity»). The «No Water»
indicator (14) lights up when there is not enough water in the appliance.
The speed level is set to the lowest speed and the desired air humidity
is set to continuous operation.
4. If the motion sensor does not detect any motion for 10 seconds, the
illumination of the buttons and the symbols goes out (only the current
relative humidity «Air Humidity» will be displayed in %). Activate the
buttons by moving your hand over the display (9). Alternatively, the dis-
play can also be activated by touching the lower part with your hand.
5. If no mode has been set, the desired air humidity can be adjusted (be-
tween 35 – 65 % and continuous operation «CO»): Push the «Air Humid-
ity» button. The display will blink. You may now select the desired air
humidity in increments of 5 % by repeatedly pressing the «Air Humid-
ity» button (the display will blink while settings are being adjusted). The
selected value is saved if no other adjustments are made after approx.
10 seconds. The display changes to the current measured air humidity.