Read Before Use; Montage - JAP TF-W Manual De Instrucciones

Read before use

Carefully read the warning and safety precaution.
Check the product for any visible damage. If any, contact japproducts as soon as possible.

Montage

Before using this appliance please assemble it following the instructions below step by step.
1. First, put the cord through the pedestal. Then carefully push the motor with control panel
through the base until it clicks into place. (Fig 2.A)
2. Screw the base to the motor with control panel with the three screws provided. (Fig 2.B)
3. Place the safety cover (right) against the head piece of the motor. Make sure the mounting
pieces go through the appropriate holes. (Fig 2.C)
4. Attach the safety ring to the head piece of the motor (Clockwise to fasten, counterclockwise
to loosen). Make sure the safety cover (right) is properly secured. (Fig 2.C)
5. Place the propeller on the head piece. Make sure that the recesses on the rear of the
propeller fit snugly into the mounting pieces.
6. Attach the propeller headpiece to the screw thread and tighten it (Counterclockwise to
fasten, clockwise to loosen.) (Fig 2.D)
7. Attach the safety cover (left) to the safety cover (right). Note that both safety covers have an
opening to fasten the nut and bolt. Make sure that both openings overlap. (Fig 2.E)
8. Close all mounting clips securing both security covers together. (Fig 2.F)
6