How To Maintain - GE 106727 Guia Del Propietario

How To Maintain

NOTE: Turn off the power switch and unplug the electrical cord to service cleaning nozzles.
C. Cleaning the Carpet Shampooer/Extractor's Suction Cover
D. Cleaning the Carpet
Shampooer/Extractor's
Plunger, Boot Seal and
Filter
1. Remove the clean water solution tank.
2. Remove the Plunger, Boot Seal and Filter
Assembly by lifting up the Boot Seal. This
will pull out the Plunger, Boot Seal and
Filter Assembly (see Figure 1).
3. Remove the Reservoir Filter and clean it
by removing any debris and rinsing with
water.
4. Reinsert the Filter on the Plunger stem
and place the Assembly directly into the
reservoir. Install this assembly into the
reservoir by pressing down on the top of
the plastic plunger. Do not press down on
the rubber boot seal.
Make sure the plunger stem
IMPORTANT!
is placed into the hole in the
bottom of the reservoir for
a secure fit (see Figure 2).
5. Replace the Clean Water Solution Tank
back onto the carpet shampooer/
extractor unit.
16
Suction
Cover
1. Remove the screws from each
2. Lift the suction cover off and
3. Replace the suction cover by
Tabs
4. Align one of the screw holes in
Suction Cover Gasket
(around rim of suction
cover area on unit)
FIGURE 1
Plunger, Boot Seal and
Filter Assembly
side of the suction cover.
clean the area of dirt and lint.
sliding the tabs on top of the
suction cover into the top slots
on the hood. Make sure the
suction cover gasket is in place
on the unit before replacing
cover.
the suction cover, hood and base
then secure with screw. Also
complete this step for second
screw hole.
Boot Seal
Plunger Stem Assembly
Reservoir Filter
FIGURE 2
Correct installation
of assembly