Disassembling; Initial Setup - Phonic Road Gear 160 PLUS Manual Del Usuario

Caution
● Use the AC power cable supplied with the RoadGear sets
only
● When buying the RoadGear, the AC power cable will be
specific to the safety and code requirements of the Country
of purchase
● The ground (earth) pin of the AC power cable's male con-
nector should under no circumstances be removed.
● When taking the RoadGear abroad, check local voltage lev-
els and ensure the appropriate power standard is used, as
selected by the power selection switch on the rear panel.
● When the RoadGear is in use, the storage compartment
door much be kept open for better ventilation
Dissassembling
To follow is the most convenient way to open and close the
RoadGear kits. Following these instructions will ensure trou-
ble-free setup of the RoadGear.
1. You should first unclip docking locks ① and ② (indicated
below) on the either side of the RoadGear.
2. After unlocking these docking locks you can then open the
top lock ③. This ensure the RoadGear pieces come apart
smoothly.
3. Stand the powered mixer upright.
4. To re-assemble the RoadGear pieces, the same order
should be taken (side locks first, followed by the top).This
way the pieces will be held securely and firmly together.
5. When using the RoadGear speakers, ensure that the dock-
ing locks on the rear are locked back into place, to ensure
they don't scratch the surface on which they sit.
Push botton in
to release lock
1
Road Gear 160 Plus/Road Gear 260 Plus

Initial Setup

Please ensure you take note of all setup instructions listed in
this manual. The RoadGear 160 and 260 are both used as
normal PA systems and therefore all care should be taken in
ensuring the correct setting up of equipment.
1. Disassembling the mobile RoadGear set and remove the
speakers from the top of the kit. Remove all items you wish
to use in your PA system from the RoadGear's storage area.
Also, place the mixer and speakers in a suitable place.
2. Contect the two speakers to the Powered Mixer, via the
supplied speaker cable. An optional speaker stand may be
used to increase the height of the speakers.
NB. No devices other than speakers should be connected to
the speaker outputs. Doing so will likely cause damage to
the device. Also, guitar should not be used to connect am-
plifiers to speakers.
3. Plug all necessary instruments and equipment into the
device's various inputs as required. This may include line-
signal devices, as well as microphones and/or guitars, key-
boards, ect.
4. Plug any necessary equipment into the device's various
outputs. This could include monitors, signal processors,
and/or recording devices.
5. Ensure all input and out levels are set to the leftmost posi-
tion.
6. Plug the supplied AC cable into the AC inlet on the back of
the RoadGear mixer.
NB. Ensure the power cable has no scratches or cuts that may
reveal the wire beneath before plugging into the provided
powered mixer as constant setting up and disassembling of
equipment may cause insulation wear.
7. Plug the supplied AC cable into a power outlet of a suitable
voltage.
8. Turn the mixer power switch to the on position and set all
input and output at appropriate levels to suit your needs.
9. When the RoadGear is in use, the storage compartment
door must be kept open for better ventilation.
5