What's Next - Sony StorStation LIB-D81 Guia De Inicio Rapido

LED Lit/Flashing
CLEANING
Flashing (green)
Notes
Notes
1 To begin cleaning the AIT drive, insert the cleaning
cartridge in slot CL/8 and press the CLEAN button for
at least three seconds.
2 If you are unable to open the front door, it may be
locked from your backup software.
3 If the cartridge is not ejected from the AIT drive when
an error occurs, proceed as follows.
(1) Press the DOOR button for at least five seconds.
The cartridge is forcibly ejected from the AIT
drive and the front door unlocked.
(2) Restart the AIT autoloader.
(3) Restart the system.
4 If [ ] appears to be rotating or [E J] flashes on the
display, then the loader is in operation. Depending on
the state of the cartridge, it may take up to 20 minutes
for it to be detected.
5 Pressing the CLEAN and DOOR buttons
simultaneously for at least five seconds starts Disaster
recovery.
6 In the code reference table, "XX" refers to an error
code.
7 Cleaning normally takes approximately one minute.
However, if there is a data cartridge in the drive, it
must be returned to its slot before cleaning can begin.
Furthermore, if the tape of the cartridge in the drive is
damaged, it may take some time for it to be
successfully ejected. For this reason, cleaning may
take up to 20 minutes.
10

What's Next?

Code Description
AIT drive cleaning
C L
request.
What's Next?
Read the Operating Instructions, install cartridges, then
make the required settings to use the library. Procedures
for making settings and using the library are given in the
Operating Instructions (PDF) together with usage
precautions and other necessary information. Please be
sure to read it.
Remedy
Clean the AIT drive. If the CLEANING
LED starts flashing again, repeat
cleaning up to three times. Also verify if
the cleaning cartridge has reached the
end of its service life. If after performing
the above the CLEANING LED
continues flashing, contact customer
service for repair.