ENFORCER SM-226LQ Manual De Instrucciones

SM-226LQ / SM-226L-3Q
Overhead Door Magnetic Contacts
Manual
Installation:
Please read the manual carefully before installation.
1. Mount the contact on the floor near the bottom of the door. Ensure that the contact switch is in a safe location away
from equipment interference and near where the magnet will be when the door is closed.
2. Run the armored cable to the side and connect its two wires to two wires from the alarm control panel
3. Mount the magnet on the roll up door so that it will trigger the contact when the door is closed. Be sure that the gap
between the contact and magnet does not exceed 2
Specifications:
Model
Loop type
Electrical configuration
Operation gap
Connectors
Switch
Material Contacts
Magnet
Contact rating
Operating voltage
Operating temperature
Switch cycles
Switch dimensions
Magnet dimensions
Magnet type
California Proposition 65 Warning:
more information, go to www.P65Warnings.ca.gov.
LIFETIME LIMITED WARRANTY:
SECO-LARM's obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. Under no circumstances will SECO-LARM be
responsible for any costs or charges for removal, installation, or reinstallation. This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse,
neglect, repair, or alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly as a result of causes
other than defects in material and workmanship. The sole obligation of SECO-LARM, and the purchaser's exclusive remedy, shall be limited to repair or replacement only, at SECO-LARM's option.
In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property damages of any kind to the purchaser or anyone else. This lifetime limited
warranty is for products sold and installed in the United States and Canada. For all other countries the warranty is 1 (one) year.
NOTICE:
The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also
not responsible for misprints. All trademarks are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 2020 SECO-LARM U.S.A., Inc. All rights reserved.
SECO-LARM
16842 Millikan Avenue, Irvine, CA 92606
Phone: (949) 261-2999 | (800) 662-0800 Email: sales@seco-larm.com
SM-226LQ only
SM-226LQ
Closed loop
N.O. (SPST) NO/NC/COM (SPDT)
3
2 / " (70mm)
4
24" (61cm) Armored leads
Heavy-duty cast-aluminum case
Deactivated rhodium on gold underplating
ABS plastic on L-bracket
1.0A@10VDC (max.) 0.2A@10VDC (max.)
10W (max.)
12~24 VDC
-15°~160° F (-25°~70° C)
50 Million (0.1mA@5VDC)
5 3 7
4 / "x1 / "x / " (109x44x11 mm)
16 4 16
15
3 / "x2"x2" (100x51x51 mm)
16
Alnico 5
These products may contain chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For
This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for the lifetime of the product.
®
U.S.A., Inc.
Features:
• Operating voltage: 12~24 VDC
• 2 3 / " (70mm) Gap for overhead doors
4
• Adjustable to fit most door-channel widths
• 24" (61cm) Armored wire leads
• Reed switch has deactivated rhodium on gold under-
plating
• SM 226LQ For closed-loop circuits
• SM-226L-3Q For open or closed-loop circuits
• IP66 – Epoxy sealed for weatherproof installation
Type: S
• Mounting bracket included
49J5
• Limited lifetime warranty
Parts List:
1x Contact Switch
1x Magnet with bracket
3 / " (70mm).
4
NOTES:
1. Contact and magnet must be installed on the
SM-226L-3Q
2. On wood surfaces, the magnet must be
Open/Closed loop
3W (max.)
Website: www.seco-larm.com
1x Manual
protected side of the door.
installed at least 1 / " (6.4mm) from the switch
4
housing to comply with UL 681 installation
requirements .
Alarm Control
MI_SM-226Lseries_201222_ML.docx
Panel
®
PITSW1
763-226-1%