STAR Water Systems HomeGuard OPTIMA Manual Del Usuario página 2

This product is warranted for one year from the date of purchase or two
years from the date of manufacture, whichever occurs first. Subject to the
conditions hereinafter set forth, the manufacturer will repair or replace to the
original consumer, any portion of the product which proves defective due to
defective materials or workmanship. To obtain warranty service, contact the
dealer from whom the product was purchased. The manufacturer retains
the sole right and option to determine whether to repair or replace defective
equipment, parts or components. Damage due to conditions beyond the
control of the manufacturer is not covered by this warranty.
THIS WARRANTY WILL NOT APPLY: (a) To defects or malfunctions
resulting from failure to properly install, operate or maintain the unit in
accordance with printed instructions provided; (b) to failures resulting
from abuse, accident or negligence or use of inappropriate chemicals or
additives in the water; (c) to normal maintenance services and the parts
used in connection with such service; (d) to units which are not installed in
accordance with normal applicable local codes, ordinances and good trade
practices; and (e) the unit is used for purposes other than for what it was
designed and manufactured.
RETURN OF WARRANTED COMPONENTS: Any item to be repaired
or replaced under this warranty must be returned to the manufacturer
at Kendallville, Indiana or such other place as the manufacturer may
designate, freight prepaid.
1. The system is designed for installation in sumps with
minimum of 18" diameter and 22" deep. For smaller
applications, consult factory.
2. Remove all debris from the pit before installation.
3. Be sure that the pump is clamped securely to the
primary pump discharge pipe and that the two pumps
do not interfere with each other.
4. Install a serviceable check valve in the discharge line.
1. DO read all installation materials supplied with the
pump.
2. DO inspect unit for any visible damage caused
by shipping. Contact dealer if unit appears to be
damaged.
3. DO clean all debris from the pit before installation.
4. DO install a union check valve (see STEP 3) in the
discharge line. DO NOT use a discharge pipe smaller
than the recommended pump discharge sizes.
5. DO install a filter or strainer in the water supply line
before the pump to prevent small particles from
clogging the operating valve.
Limited Warranty
Helpful Hints For Easy Installation
Do's And Don't's For Installing A Unit
© Copyright 2013 Star Water Systems. All Rights Reserved.
THE WARRANTY PROVIDED HEREIN IS IN LIEU OF ALL OTHER
EXPRESS WARRANTIES, AND MAY NOT BE EXTENDED OR MODIFIED
BY ANYONE. ANY IMPLIED WARRANTIES SHALL BE LIMITED TO THE
PERIOD OF THE LIMITED WARRANTY AND THEREAFTER ALL SUCH
IMPLIED WARRANTIES ARE DISCLAIMED AND EXCLUDED. THE
MANUFACTURER SHALL NOT, UNDER ANY CIRCUMSTANCES, BE
LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES,
SUCH AS, BUT NOT LIMITED TO DAMAGE TO, OR LOSS OF, OTHER
PROPERTY OR EQUIPMENT, LOSS OF PROFITS, INCONVENIENCE
, OR OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY
TYPE OR NATURE. THE LIABILITY OF THE MANUFACTURER SHALL
NOT EXCEED THE PRICE OF THE PRODUCT UPON WHICH SUCH
LIABILITY IS BASED.
This warranty gives you specific legal rights, and you may have other rights
which vary from state to state. Some states do not allow limitations on
duration of implied warranties or exclusion of incidental or consequential
damages, so the above limitations may not apply to you.
WARRANTY VALID IN CANADA AND MEXICO.
5. Install a filter or strainer in the water supply line before
the pump. Size the filter/strainer properly to minimize
pressure drop, while retaining particles at least 0.020"
(0.5 mm) in diameter.
6. Test the unit immediately after installation. Refer to
STEP 5.
7. Check the Float ON/OFF levels per STEP 2 of the
instructions.
8. Obtain model number, date code, and installation
instructions before calling factory.
6. DO test the pump immediately after installation to be
sure that the system is working properly.
7. DO review all applicable local and national codes and
verify that the installation conforms to each of them.
8. DO NOT use the Home Guard
DO NOT use the Home Guard
wastewater, sewage, effluent, or water with debris in it.
9. DO NOT use a garden hose. Garden hose is not
designed to hold municipal pressure indefinitely and
could leak or burst causing flooding. The Home Guard
Optima requires a permanent piping method such as
copper, PEX, or CPVC.
2
Optima in hot water.
®
Optima to remove
®
®