SEVERIN KGK 8943 Instrucciones De Uso página 27

• Defrost frozen appliances in the refrigera-
tor. Foods keep their taste when they are
defrosted slowly, and the emitted cooling
energy from these appliances can be used
to maintain the intended temperature in the
refrigerator.
• If the appliance is turned off for a longer
period of time, e.g., because of a mains
failure, leave the door closed. Thereby, a
more significant loss of cooling energy can
be avoided. The maximum storage time
during malfunction can be taken from the
appliance specification sheet at the end of
the manual. Because of the higher interior
temperature, the storage time for food is
shortened.
Data for expiry dates of frozen food are indi-
cated in the chart per month.
Do not store the frozen food longer than the
given time in the freezer. Pay attention to the
expiry date of the frozen food indicated by
producer.
Refrigerator:
• Store the food only packaged or covered
in the refrigerator, in order to sustain the
flavour and the freshness. Especially foods
with a strong smell or prone to absorbing
smell (cheese, fish, butter, among others)
have to be stored separately.
• At first, set an average cooling temperature.
If the cooling is too strong, set a higher
temperature and if the cooling is too weak,
set a lower temperature.
If frost is built upon the back wall, then
the cause of this could be that the door
was opened too long, warm dishes were in
the appliance or the temperature was set
too low.
• Warm foods have to be cooled down to
room temperature before they can be
stored in the appliance.
• Make sure that the door is closed correctly
and that it is not blocked by cooled food.
Ice Cube Production
There is an ice cube tray for the ice cube
production. It is filled with drinking water up
to ¾ and placed afterwards in the freezer. If
the Fast Freezing feature is used, the process
takes about an hour. The ice cubes can be
separated more easily after they are exposed
to room temperature for 5 minutes.
Cleaning and Defrosting (Maintenance)
Cleaning
• Always pull the mains plug before cleaning.
• Do not pour water into the appliance.
• Tepid water with a bit of washing-up liquid
is suitable for the regular maintenance. In
order to avoid an unpleasant smell in the
cooling room, a cleaning of the latter once
a month is recommended.
• Clean the equipment separately with rins-
ing water, not in the dishwasher.
• Do not use aggressive, abrasive or alcoholic
detergents.
• After cleaning it with clear water, wipe the
surface and carefully dry it off. Subsequent-
ly, plug the mains plug with dry hands.
• In order to save energy and maintain the
efficiency, you should clean the condenser
(on the backside) and the compressor at
least twice a year with a broom or vacuum
cleaner.
• The rating label in the interior of the appli-
ance cannot be damaged or even removed
while cleaning.
Defrosting
The appliance does not have to be defrosted,
just cleaned. The evaporator is in the back
wall. Therefore, the back walls in the cooling
room can get covered with frost. Whenever
the compressor is not operating, the frost can
melt. The occurring water is guided through a
hose system into a bowl on the compressor,
where it is vaporised by the occurring heat.
- 27 -