Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
Thank you for purchasing your Atlantic 60 Watt Transformer. Multiple 12 volt fixtures can be
connected to this all-weather outdoor rated transformer.
Prior to Operation and Installation
Caution:
• DO NOT operate this product under any conditions other than those for which it is specified.
Failure to observe these precautions can lead to electrical shock, product failure
or other problems.
• Follow all electrical codes when installing the Atlantic 60 Watt Transformer.
• To reduce the risk of electrical shock, connect transformer to a 120 volt receptacle protected
by a ground fault circuit interrupter (GFCI).
• Low voltage lights connect via a 2-wire quick-connect plug that is gasketed for outdoor use.
Quick-connect plugs are not waterproof and should not be submersed.
• Always use dielectric grease on all connections.
• The input power to the 60 Watt Transformer is 120 volt AC and the output is 12 volt AC.
Removing or tampering with the cord will damage the transformer and void the warranty.
• The transformer is weather resistant, not water proof. Do not submerse the transformer. It
must be mounted off the ground close to the power source. Failure to do so will void
the warranty.
Warranty
Atlantic TRANS60 carries a one-year limited warranty.
This limited warranty is extended solely to the original purchaser commencing from the date
on the original purchase receipt and is void if any of the following apply:
• The cord has been cut or altered.
• The transformer has been misused or abused.
• The transformer has been disassembled or modified other than as described in this manual.
This warranty excludes labor/cost of labor for removal or installation of any product.
Troubleshooting Guide
Always turn off power before inspecting the transformer. Failure to observe this precaution can
result in injury or damage to the transformer.
Before attempting repairs, carefully read through this instruction booklet. If the problem
persists, contact your dealer.
Problem
Lights will
not turn on
2
Possible Cause
No input power to
the transfomer
No outlet power from
the transformer
Possible Solution
Verify power to the outlet is on / Check
GFCI reset
Remove fuse cover, inspect fuse and replace
if necessary
Use a volt meter to verify transformer is
producing 12V AC
Publicidad
