geberit KSS-160 Manual De Instrucciones página 13

Operation
Welding Geberit PE and
Geberit Silent-db20 pipes and
fittings
WARNING
Risk of injury from burns
Do not touch the welding plate during
operation or during the cooling-down
phase.
Insert the welding plate into the provided
stand during breaks in work.
1
Connect the mains plug to the power supply
system.
Geberit welding plate KSS-160/KSS-200:
the red signal lamp lights up during the heat-
up phase. Once the welding temperature
has been reached (after approx. 8 minutes),
the green signal lamp lights up.
KSS-160
KSS-200
Geberit welding plate KSS-315:
the heat-up phase is monitored by the built-
in temperature regulator. The welding
temperature is reached after approx.
20 minutes of heating.
KSS-315
B773-003 © 02-2014
997.771.00.0 (09)
230 V
120 V
00:08:00
00:20:00
2
Cut the pipes or fittings to length at a right
angle.
90°
Heating the pipes or fittings:
• ø 32 mm only possible by manual
actuation
• ø 40–75 mm possible by manual actuation
or with the welding machine
• ø 90–315 mm only possible with the
welding machine
3
Heat pipes or fittings by pressing the side to
be welded against the welding plate with the
required contact pressure.
Connecting the pipes or fittings:
• ø 32 mm only possible on the jointing
guide
• ø 40–75 mm possible on the jointing guide
or with the welding machine
• ø 90–315 mm only possible with the
welding machine
4
To achieve a high-tensile joint between
pipes and fittings, apply even pressure to
bond the pipes or fittings together.
EN
13