Intermatic InTouch CA5500R Manual De Instrucciones

Model CA5500R & CA5500B
Hand-Held Remote Control & Charger Base Station
CA5500B
Specifications:
Wireless RF Control
Operating Temperature Range:
32°F (0°C) to 104°F (40°C)
Rechargeable Nickel Metal Hydride
Caution: To avoid fire or serious
damage to the remote control, use
only Intermatic CA5500BAT
replacement battery.
Ratings:
Wall-pack Transformer:
Input:120VAC, 50/60Hz;
Output 9VDC 500ma (CATRFM)
RF Information:
Minimum Range:
50ft indoor; 100ft outdoor
Frequency: 908.42 MHz
Network Information:
Mesh Network - Each line powered
node acts as a repeater to route
distant signals.
Data Rate: 9600 bits/second
Size: 232 Z-Wave™ Nodes
The CA5500 Remote and Base Station are
compatible with Z-wave™ enabled networks and devices.
Z-wave network is designed to act as a repeater forming a mesh network eliminating
radio "dead spots" and providing the highest level of reliability.
Features
- The CA5500B provides InTouch
capabilities including; extended signal hopping, full status of InTouch and legacy
Z-wave devices, system messaging, in-field firmware upgrades, advanced scene
control, and much, much, more.
- Multiple location On/Off & Raise/Lower control when used with Z-wave enabled
devices.
- Allows control of up to 9 individual pre-set scenes containing any number of Z-wave
enabled devices.
- Features individual scene status feedback for enhanced control.
- Separate focus and control buttons allows the user to custom mix scene selections
and device levels.
- Home key provides for quick de-selection of scenes.
INSTALLATION:
1. Plug included wall pack transformer into standard 120VAC receptacle.
2. Attach plug-end of cord to CA5500B base station.
3. Open battery cover on Hand-Held Remote and plug in battery connector.
Reinstall battery cover.
4. Firmly seat CA5500R hand-held remote in base station. Indicator on base station will begin to pulse to
indicate charging. Back lights on hand-held unit will light and remain lit while in base station.
5. Charge remote for a minimum of 12 hours initially. Indicator on base station will stop pulsing when remote
is fully charged.
6. If indicator on base station turns red, a battery or communications failure is indicated. Reseat the remote in
the base, if the condition persists contact technical services.
7. Remote may be used in or out of the base station. When used as a hand-held back lights will go to sleep
20 seconds after last button press. To re-awaken, press any button on the remote.
8. Operation: Press scene number button(s) to focus control activities; Press "Enter" to toggle selected
scene(s); Press r s / to raise or lower selected scene(s) level; Press the home key to clear selected
scene(s)
9. For programming instructions refer to the
CA5500R
enhanced radio frequency controllers
Each line powered node in a
™ server function for enhanced Z-wave
InTouch Installer & Users Guide (158CA12789).