Connecting The System; Installation; Precautions Before Installation; Before Installing - Pioneer XDV-10 Manual De Instrucciones

Connection

Connecting the system

AVIC-EVO1 main unit
(sold separately)
RGB input
RGB output
Power supply
This product
Power cord
(supplied with
AVIC-EVO1)
RGB cable

Installation

Precautions before installation

CAUTION
Never install this product in places where, or in a manner
that:

Could injure the driver or passengers if the vehicle
stops suddenly.
 May interfere with the driver's operation of the vehi-
cle, such as on the floor in front of the driver's seat,
or close to the steering wheel or gearstick.

To ensure proper installation, be sure to use the sup-
plied parts in the manner specified. If any parts are
not supplied with this product, use compatible parts
in the manner specified after you have the parts'
compatibility checked by your dealer. If parts other
than supplied or compatible ones are used, they may
damage internal parts of this product or they may
work loose and the product may become detached.
 Never install this product in front of or next to the
place in the dashboard, door, or pillar from which one
of your vehicle's airbags would deploy. Please refer
to your vehicle's owner's manual for reference to the
deployment area of the frontal airbags.

Before installing

 Consult with your nearest dealer if installation requires
drilling holes or other modifications of the vehicle.
 Before making a final installation of this product, temporarily
1 m
connect the wiring to confirm that the connections are
correct and the system works properly.

Installation notes

 Do not install this product in places subject to high tempera-
tures or humidity, such as:
 Places close to a heater, vent or air conditioner.

Places exposed to direct sunlight, such as on top of the
dashboard.
 Places that may be exposed to rain, such as close to the door
or on the vehicle's floor.
 Install this product horizontally on a surface within 0 to
30 degrees tolerance (within 5 degrees to the left or right).
Improper installation of the product with the surface tilted
more than these tolerances increases the potential for errors
in the vehicle's location display, and might otherwise cause
reduced display performance.
30°

When installing, to ensure proper heat dispersal when using
this product, make sure you leave ample space behind the
rear panel and wrap any loose cables so they are not block-
ing the vents.
Leave ample
5 cm
space
5 cm

The semiconductor laser will be damaged if it overheats, so
don't install this product anywhere hot— for instance, near a
heater outlet.

Installing this product

p Before you completely install this product, connect the
cables.
1 Open the glove box.
To prevent damaging things inside the glove box, remove them
from the glove box.
2 Insert this product into the housing structure
for DIN audio equipment in the glove box.
Gently slide into the housing structure until you can hear snap-
ping sounds and be sure that this product is firmly fixed.

Removing this product

If you do not wish to use the DVD player anymore, you can
remove it.
1 Insert the separately sold extraction keys into
both sides of the unit until they click into place.
5