• Do not fill the freezer full of products. You should
leave space between items and the inner surface of
the cabinet, so as to keep good ventilation of cold air
and freeze evenly. Do not put in any bottled or canned
beverage with freezing point above the temperature in
the cabinet when it is below zero.
• For foods that should be moisture-free or lose water
easily, wrap them up with hermetical food bags or
fresh films before putting in the cabinet for the sake of
avoiding smell-mixing and reducing frosting.
• The freezer should be cleaned regularly. When
cleaning, turn off the power, take out the foods in the
cabinet, clean the inside using water or a little neutral
detergent.
• Do not use boiling water, acid, chemical diluents, oil,
or dirt-removing powder.
• Wipe dry after cleaning.
• Use light soap water when cleaning the door seal,
apply a little of talcum powder on it after natural drying
to extend its service life.
• The freezer should be cleaned regularly. When
cleaning, turn off the power, take out the foods in the
cabinet, clean the inside using water or a little neutral
detergent.
• Do not use boiling water, acid, chemical diluents, oil,
or dirt-removing powder.
• Wipe dry after cleaning.
• Use light soap water when cleaning the door seal,
apply a little of talcum powder on it after natural drying
to extend its service life.
Breakdown
The indicator is not on.
The compressor doses not
start.
The indicator is on ,but the
com- pressor doesn't work and
buzzes only
The compressor stops a
minute after start, and restarts
after a few minutes, and so
repeatedly.
The compressor works
normally, but the temperature
in the cabinet decreases too
slowly.
The noise is too loud
The following are not faults:
• When the freezer is working or after stopping for a while, the refrigerant in the pipes is cycling and will give off a
"running water" sound. This is normal.
• The surface temperature of the compressor can be up to 70°~80°F when it is working.
• The back side of step freezer gives off heat.
• In rainy season, the outer surface of the cabinet may have dew, which makes no defects on normal use. Just dry it
with a piece of cloth.
Nexel Chest Freezer
Food Storage
Maintenance
Defrosting
Troubleshooting
Case
The plug isn't connected to the socket properly.
No power
No power
The power voltage is < 98V.
The power voltage is > 132V.
The door is opened too frequently.
There is too much food in the cabinet and/or placed
improperly.
The frost film is too thick.
The surface of the condenser is too dirty.
The door seals badly.
The freezer is on an uneven surface or is unstable.
Hardware of the freezer is loose.
There's contact between pipes.
• Storage of volatile and combustible gases, liquids
such as strong alkalies, strong acids, gasoline, etc. is
forbidden.
• Never put hot food directly in the freezer. Food should
be cold or frozen before placing it inside.
• The cabinet is intended exclusively for the storage and/
or display of packaged foods only.
• Use soft cloth with water or a little detergent to clean
the out surface. Note, keeping the power supply and
lower part of connect wires away from water to avoid
electricity leakage.
• Except common breakdowns, those who are not
certified service technicians should not disassemble
or repair the freezer on their own. Unauthorized repair
of electrical part such as compressor, temperature
controller is forbidden and will void warranty.
• Use soft cloth with water or a little detergent to clean
the out surface. Note, keeping the power supply and
lower part of connect wires away from water to avoid
electricity leakage.
• Except common breakdowns, those who are not
certified service technicians should not disassemble
or repair the freezer on their own. Unauthorized repair
of electrical part such as compressor, temperature
controller is forbidden and will void warranty.
Removal method
Connect plug to socket.
Check power connection.
Install a power-regulator more than 1000W
Reduce the amount of times the door is open.
Decrease the amount of food in the cabinet and/or keep enough
space between foods for proper ventilation of cold air.
Take out foods and defrost.
Stop and clean the condenser.
Adjust the door seal.
Place on an even surface.
Check and tighten all hardware.
Carefully separate pipes.
3