Assembly Instructions; List Of Components - Tanita WB-3000 Manual De Instrucciones

1. List of Components

Base (fully assembled and pre-wired to display assembly)
Cable (Base side)
Lower Pillar Assembly
Screw
Cable (Top Head Display Assembly Side)
Top Head Display Assembly (fully assembled and pre-wired to base)
Back Cover
Front Cover
Top Height Rod Assembly (fully assembled with pivoting height measuring lever)
Height Rod Arm
Lower Height Rod Assembly
2. Assembly
1) Carefully remove all components from the box.
2) Place all items on the floor side by side.
3) Install the Lower Pillar Assembly into the Base using the four (4) Screws while carefully avoiding pinching the cable.
4) Assemble the Top Head Display into the Lower Pillar assembly while carefully inserting the cable into lower pillar assembly and extending it the full
length of the lower pillar.
5) Connect the Cable from the bottom of the lower pillar assembly to the cable on the base.
6) Attach the Back cover onto the back side of the bottom of lower pillar assembly.
7) Attach the Front cover to the front side of the lower pillar assembly while holding the Back cover
securely in place.
8) Assemble the top height rod assembly to the lower height rod assembly correctly.
9) Slide the assembled height rod into the height rod opening on the pillar assembly. Push all the way
down.
CAUTION
• Be careful not to catch your fingers during assembly.
4

5. Assembly Instructions

5)