Before Your First Use
Carefully unpack the coffee maker and remove all packaging materials. Wipe the
heating stand with a clean, damp cloth. Do not immerse the heating stand in
water or other liquid. To remove any dust that may have accumulated on the
removable parts during packaging, wash the carafe, lid and filter basket with
warm soapy water. Rinse and dry. We recommend that prior to brewing your first
pot of coffee, you "brew" just the cold water without ground coffee or a paper
filter. This will remove any dust that may have settled inside the coffee maker.
Operating Instructions
BREWING COFFEE
1)
Open the water tank lid(1) and fill the water tank with desired amount of cold
water.
2)
Swing the filter basket holder(2) outward to your right. Lift out the filter
basket(3). Insert a #4 cone-shaped filter into the filter basket(3).
3)
Place the desired amount of ground coffee into the filter.
4)
Insert the filter basket(3) with filter in the filter basket holder(2). Be sure the
filter basket(3) is seated properly in the filter basket holder(2). Swing the
filter basket holder close and snap into place.
NOTE: Do not operate your coffee maker if the filter basket holder does not
close completely. If the door does not close completely, check to see
that the filter basket is properly seated and snap the door back into its
place.
5)
Press the right power button(4) to begin brewing. In 15 minutes the coffee
maker will complete the brewing cycle and switch over to warming mode,
keeping the coffee hot.
6)
Press the right power button(4) again to turn the coffee maker off when the
carafe is empty or when the coffee maker is not in use.
MAKING ESPRESSO
1)
Remove the espresso filter basket(10) by grabbing the handle and sliding
1/4 to the left. The espresso filter basket(10) will now be released.
2)
Place the espresso filter(11) in the espresso filter basket(10).
3)
Fill with fresh ground espresso coffee to the desired amount. Clean any
excess coffee from the rim of the espresso filter basket(10). This will assure
proper fit under the brew head.
4)
Place the retainer clip(14) in the release position by pulling the clip back
toward your hand. Place the espresso filter basket(10) underneath the brew
head so that the handle is positioned to the left of the center. Lift the
espresso filter basket(10) up and insert it into the brew head. Make sure the
7