Publicidad
FUNCTIONING
Continuity test BNC, RJ11, RJ45
1. Turn your cable tester Category 5 with the Power
switch, LED indicator lights red intermittently.
2. Connect one end of the cable with RJ-45, BNC
or RJ11 to one of the two parts of the tester (the
tester consists of two parts) and the other end of
the cable into the other side of the tester.
3. If the cable is well armed (with continuity and
each pair corresponds) the tester will indicate by
means of LEDs that it is, the green LEDs light up
consecutively; will continue to test each of the pairs
indefinitely until you disconnect or turn off the
tester.
Publicidad
