English; Explanation Of Symbols; Safety Notes For Pressure Washer; Connecting To The Mains - Bosch GHP 5-13 C Manual Original

OBJ_BUCH-1751-003.book Page 11 Friday, July 14, 2017 12:19 PM
Entsorgung
Hochdruckreiniger, Zubehör und Verpackungen sollen einer
umweltgerechten Wiederverwertung zugeführt werden.
Werfen Sie Hochdruckreiniger nicht in den Haus-
müll!
Nur für EU-Länder:
Gemäß der Europäischen Richtlinie 2012/19/EU über Elekt-
ro- und Elektronik-Altgeräte und ihrer Umsetzung in nationa-
les Recht müssen nicht mehr gebrauchsfähige Elektro- und
Elektronikgeräte getrennt gesammelt und einer umweltge-
rechten Wiederverwertung zugeführt werden.
Änderungen vorbehalten.

English

Safety Notes

Explanation of symbols

General hazard safety alert.
Never direct the water jet
at people, animals, the unit
or electric components.
Warning: High pressure jets can be dan-
gerous if subject to misuse.
According to the applicable
regulations, the appliance
must never be used on the
drinking water network without a
system separator. Use a separator as
per IEC 61770 Type BA.
Water flowing though a system sepa-
rator is considered not drinkable.
For self priming use special suction
kit 3 m long (F 016 800 335).

Safety Notes for pressure washer

Read all safety warnings
and all instructions. Failure
to follow the warnings and in-
Bosch Power Tools
structions may result in electric shock,
fire and/or serious injury.
The warning and information signs
attached to the unit provide impor-
tant information for safe operation.
Apart from the information in the op-
erating instructions comply with the
general safety regulations and regu-
lations for the prevention of acci-
dents.

Connecting to the mains

The voltage indicated on the rating

plate must correspond to the voltage
of the power source.
We recommend that this equipment

is only connected into a socket which
is protected by a circuit-breaker that
would be actuated by a 30 mA residu-
al current.
This is a class I unit and may only be

connected to properly earthed power
sources.
Remove the plug from socket when-

ever the machine is left unattended
for any period.
The electric supply installation

should comply with IEC 60364-1.
If the supply cord is damaged, it must

be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
If the plug is damaged, pay attention

to the following:
Plugs and sockets situated near the

work site or outdoors should be to
class IP 55 of BS 5490 to provide ad-
equate protection against ingress of
water, etc. and cable entries require
effective sealing. Rubber shrouds
Autogoods "130"
English | 11
1 609 92A 3EP | (14.7.17)