auna PRO DisGo Box 2100 DVD Manual Del Usuario página 23

Using the Wireless UHF Microphone
The PA speaker comes with wireless microphones to get you started straight
out of the box.
1. Tune on the unit.
2. Unscrew the bottom of the microphone to access the battery enclosure.
Insert 2XAA batteries into the
microphone. Take note the battery
polarity when inserting the batteries.
3. Replace the botton microphone cover.
4. The wireless microphone will flash
once and automatically pair with the
PA speaker, it is ready to use. If it
does not flash, check that you have
inserted the batteries correctly or
replace old batteries.
5. Adjust the volume of the microphone
by turning the MIC VOL knob located
011 top control pa11el
Notes: Please do not operate the
microphone directly in front of the PA speaker, please set the MIC VOL/
ECHO at a lower level before turning on the wireless microphone.
Operating the microphone incorrectly will cause a loud squealing noise.
Please turn off the power switch when the wireless microphone
is not in use. This will save the battery.
Using the Wired Microphone
You can connect the wired microphone to this unit using the MIC
INPUT located on the top of control panel.
1. Turn off the unit.
2. Connect your wired microphone to the MIC INPUT located ontop of the
control panel.
3. Adjust the microphone volume by tuning the MIC VOL/ECHO knobs
located on top control panel.
NOTES: You can use the wired microphone and wireless microphone at the
same time.
Connecting a Guitar
You can connect your· guitar to unit using the 1/4'' GUITAR INPUT plug.
1. Turn on the unit.
2. Connect your guitar cable to GUITAR INPU.T port on top control panel.
EN
23