Electrical Specification; Electrical Installation - SPX Johnson Pump AS888 Manual De Instrucciones

> english
Important!
AS888 must be installed so it
always can move freely and no
floating particles interrupt the
movement.
The electrical wires must be se-
cured preventing them from falling
down onto the switch.
Check AS88 occasionally during
the season ensuring that deposits
or dirt do not interrupt its ope-
ration. Check regularly that the
electrical wires have not been
damanged.

Electrical specification

Max amps
12 V DC – 15 A
24 V DC – 7,5 A
32 V DC – 5,6 A
At heavy loads a separate relay has
to be used. AS888 may only be
used for low voltages (up to 48 V).
Bilge pump control 12 or 24 V
Part No.
12 V – 34-1224
24 V – 34-1225
The bilge pump
control combined
with automatic switch
AS888 is an excellent installation
for your boat. The panel has a
3-position switch for Off, manual
On, and automatic operation –
the automatic feature operates in
combination with AS888.
Integrated fuse holder and opera-
ting light. Fuses included. The
switch is in matt black finish.
Size: 76 x 55 mm, 40 mm depth.
6

ELECTRICAL INSTALLATION

See fig. page 15
Johnson Pump submersible
bilge pump/Automatic Switch
AS888/ Bilge pump control
Always install switch AS888 and
bilge pump control or other swit-
ches or fuses between the positive
(+) terminal of the battery and the
positiv (+) connection of the pump
(brown wire, L100 red wire).
The negative (-) connection (black
wire) of the pump to be connected
directly to the negative (-) terminal
of the battery. Fuse size applies to
pump specification.
Electrical connections
All electrical connections must be
placed above the highest water
level. The wire connections should
be sealed with a marine sealant to
prevent wire corrosion. Insulation
or cable sheathings have to be
removed in such a way that they
end well above the highest bilge
water level.
Waste handling/
material recycling
At the products end of life, please
dispose of the product according
to applicable law. Where
applicable, please disassemble
the product and recycle the parts
material.
Original instructions