Operation - Kärcher BDS 43/Orbital C Manual De Instrucciones

2. Make sure that the mains plug is un-
plugged.
3. Swing the cleaning head upwards by lift-
ing at the handle.
Illustration O
Handle
1
Cleaning head
2
4. Centre and press the pad onto the pad
drive board.
5. Pivot the cleaning head downwards.
Filling with detergent
WARNING
Unsuitable detergents
Health risk, damage to the device
Use only recommended detergents. The
operator carries all increased risks relating
to operational safety and increased risk of
accidents if using other detergents.
Use only detergents free of solvents, salt
and hydrofluoric acid.
Adhere to the safety instructions stated on
the detergent packaging.
ATTENTION
Risk of damage
A cleaning solution with a temperature
above 50°C can damage the device.
Only fill the detergent tank with a cleaning
solution up to a maximum temperature of
50°C.
1. Fill the cleaning solution into the deter-
gent tank.

Operation

Adjusting the handle
WARNING
Danger of accident
The device can perform uncontrolled
movements if the handle is adjusted while
the motor is running.
Only adjust the handle when the device is
switched off.
1. Pull the tilt adjustment lever up and hold
it in position.
2. Bring the handle into a comfortable posi-
tion (about waist height).
3. Release the tilt adjustment lever.
4. Move the handle up and down slightly
until it latches into place.
14
Switching on the device
WARNING
Risk of injury
Without ground friction, the pad can reach
very high speeds. It can be flung away and
cause injury.
Do not switch on the device when the
cleaning head is swung up.
The maximum permissible mains grid
impedance at the electrical connection
point (see Technical data) must not be
exceeded.
Contact your electricity supplier in the case
of any uncertainties regarding the mains
grid impedance at your electrical connec-
tion point.
ATTENTION
Risk of damage
The floor covering can be damaged if the
device is operated on the same spot for a
long time.
Always move the device when it is switched
on.
1. Unwind the mains cable completely from
the cable holders.
2. Plug the mains plug into a mains socket.
3. Hold the handle firmly with both hands.
4. Press and hold the unlocking button.
5. Actuate the ON/OFF switch.
6. Release the unlocking button.
7. Release the ON / OFF switch to interrupt
operation.
1. Switch the device on.
2. Pull the cleaning solution lever when the
pad is to be supplied with cleaning solu-
tion.
3. Guide the device over the surface to be
cleaned.
4. If the area is very dirty, run over it several
times.
5. Then soak up the waste water with a wet
vacuum cleaner or wipe it up with a
cloth.
Only the BDS 43 / Orbital C Spray is
equipped with the spray system. With this
English
Cleaning
Spray system