Uline H-9459 Manual De Instrucciones

H-9459
EYEWASH DRENCH HOSE –
DECK MOUNT
TOOLS NEEDED
Electric 1/4" Drill Bit
Drill
8' Hose x 1 Handle x 1
CAUTION! In the event of a chemical splash or
spill, affected area of the victim's body must
be flushed immediately for at least 15 minutes.
For chemical spills to the eyes, user should
hold eyes open as wide as possible to permit
water to reach all areas around the eye.
NOTE: Unit should be installed by licensed
plumber.
NOTE: Thoroughly clean and flush supply line
prior to installing unit. Pipe shavings, scale,
tape and other debris can be carried through
a pipe and into unit when system is activated.
This debris can damage valve components
and interfere with proper operation of the valve.
• The water supply line should have outside diameter
of at least 1/2" and should be copper or other
corrosion-resistant material.
• Unit requires a 1⁄" diameter mounting hole. Hole
should be large enough to accommodate the
shank on the deck flange but not allow excessive
lateral movement. Minimizing the hole size provides
as large a surface as possible to secure the locknut.
PAGE 1 OF 6
1-800-295-5510
uline.com
PARTS
Deck Flange x 1 45º Panel Flange x 1
SAFETY
INSTALLATION
• Unit has a 3/8" NPT male thread on inlet.
Pour le français, consulter les pages 5-6.
Spray Head x 2
CAUTION! Rinsing affected area for 15 minutes
is only the first step in treating exposure to a
hazardous chemical. Following rinsing, victim
should be examined and treated by a doctor
or other trained medical specialist as soon as
possible.
(See Figure 1) Use Teflon® tape or other pipe sealant
to seal thread. Do not apply sealant in a way that
will allow it to enter into unit.
Figure 1
Locknut
Shank
Para Español, vea páginas 3-4.
Squeeze
Valve x 1
Deck Flange with
Handle Locator Guides
Inlet 3/8" NPT
Male
Thread
0421 IH-9459