Eg-Konformitätserklärung; Ec Declaration Of Conformity - AllvoTech DVAECP30 Serie Manual De Instrucciones

Tabla de contenido

Publicidad

EG Konformitätserklärung
Elektromagnetische Verträglichkeit EMV –
Richtlinie 2004/108/EG
Der Hersteller
ruck Ventilatoren GmbH
Max-Planck-Strasse 5
D-97944 Boxberg
Tel.: +49 (0)7930 9211-100
Industriebereich.
ruck Ventilatoren GmbH
Max-Planck-Strasse 5
D-97944 Boxberg
Boxberg, 01.07.2016
ruck
nicht beachten.
Die Produkte dürfen nur in Betrieb genommen werden,
wenn zuvor die Montageanleitung sowie die Sicherheits-
vorschriften gelesen und verstanden wurden. Bewahren
Sie die Anleitung so auf, dass sie jederzeit für alle Benut-
zer zugänglich ist. Geben Sie das Gerät an Dritte stets
zusammen mit der Montageanleitung weiter.
ruck
Die Gewährleistung gilt ausschließlich für die ausge-
leistungs- und Haftungsansprüche bei Personen- und
Sachschäden durch fehlerhafter Montage, bestimmungs-
widriger Verwendung und/oder unsachgemäßer Handha-
bung aus.
Sicherheitshinweise
ruck
ruck
Leistungsbereich, welcher in den technischen Daten sowie
stallations- und Wartungsarbeiten muss der Stromkreis unter-
Transport und Lagerung
D
EG – Einbauerklärung
Der Hersteller
ruck Ventilatoren GmbH
Max-Planck-Strasse 5
D-97944 Boxberg
Tel.: +49 (0)7930 9211-100
-
1.1.5, 1.2.1, 1.3.1, 1.3.2, 1.3.4. und 1.5.1.
-
men werden, wenn festgestellt wurde, dass die Maschine,
entspricht.
(Technischer Leiter)
Montage
-
-
-
-
-
-
Betriebsbedingungen
ruck
-
-
-
Wartung
ruck
-
-
-
Entsorgung
-
den nationalen Bestimmungen Ihres Landes.
-
-
-

EC Declaration of Conformity

Electromagnetic Compatibility (EMC)
Directive 2004/108/EC
The manufacturer
ruck Ventilatoren GmbH
Max-Planck-Strasse 5
D-97944 Boxberg
Tel.: +49 (0)7930 9211-100
-
-
The following harmonised standards were used:
-
-
ments.
-
-
ruck Ventilatoren GmbH
Max-Planck-Strasse 5
D-97944 Boxberg
Boxberg, 01.07.2016
These Installation Instructions contain important information
-
to enable the safe and proper installation, transport, com-
missioning, maintenance and dismounting of ruck fans. The
-
product has been manufactured according to the state of the
-
The product shall only be taken into service after the
-
Installation Instructions and the Safety Notes have been
read and understood. Keep these instructions in a loca-
tion where they are accessible to all users at all times. If
the equipment is passed on to a third party, the Instal-
-
lation Instructions must always be handed over with it.
-
ruck
-
-
teness of these Installation Instructions.
We accept no claims under guarantee or warranty, and
no liability for injury to persons or damage to property
arising from incorrect installation, improper use, and/or
inappropriate handling.
Safety Notes
The ruck
ruck fan if it is not in good technical
-
-
-
-
-
-
Transport and storage
-
-
personnel according to the Installation Instructions and the
-
damage to or deformation of the housing. The product must
GB
CE Declaration of Incorporation
The manufacturer
ruck Ventilatoren GmbH
Max-Planck-Strasse 5
D-97944 Boxberg
Tel.: +49 (0)7930 9211-100
herewith declares that the following product:
-
1.3.1, 1.3.2, 1.3.4. and 1.5.1.
-
when it has been established that the machine in which the
The following harmonised standards were used:
12100:2010)
-
The manufacturer undertakes to send the special documen-
which belongs to the machine, has been prepared.
(Technical Director)
Installation
poles) from the mains before installing it, and before connec-
ting or disconnecting plugs. Use an installation-sided shut-off
product cannot be switched back on again.
mend using cushioned clamps to reduce noise transmission
the electrical connections to the unit according to the circuit
-
ting into the product. Information signs must not be changed
that it is accessible for maintenance and cleaning, and can
Operating Conditions
Do not operate ruck
-
-
(4 x 10-5 bar) for the simultaneous use of a kitchen hood in
-
-
Maintenance
ruck fans are maintenance free except for cleaning at the
-
from the mains. Secure the plant so that it cannot be switched
-
dust laden air will in time accumulate on the impeller and hou-
sing. This leads to lower performance, imbalance in the unit,
-
circumstances should the interior be cleaned with water or a
Disposal
-
-
-
-
-
-
-
-
-
-
-

Publicidad

Tabla de contenido
loading

Tabla de contenido