Adding/Deleting Rts Control Points; Replacement Of A Lost Remote Control - SOMFY LTN 50 PA RTS Guia De Instalacion

6. 2. ADDING/DELETING RTS CONTROL POINTS

Find a RTS control point programmed in the motor.
Press and hold the RTS programmed control point
(A) PROG button until the shade jogs: the motor is in
programming mode.
Quickly press the RTS control point (B) PROG button
to add or delete: the shade jogs and the RTS control
point is programmed or deleted from the motor.

6. 3. REPLACEMENT OF A LOST REMOTE CONTROL

N.B.: This reset deletes all control points, but intermediate position (MY position) is retained.
N.B.: Before cutting the power, move the shade to the middle position.
Cut the power supply for 2 seconds.
1)
Switch the power supply back on for 5 to 15
2)
seconds.
Cut the power supply for 2 seconds.
3)
Switch the power supply on: the shade moves
4)
during 5 seconds (If the shade position is an end
limit, the behavior of the shade will be a jog).
Press the RTS transmitter (B) PROG button until
5)
the shade jogs: all the RTS transmitter are cleared
and the new RTS transmitter is programmed in
the motor.
Copyright © 2016 Somfy SAS. All rights reserved.
+
PROG.
A
-
PROG.
A
1
2 sec
3
2 sec
5
PROG.
B
Non contractual images
EN
PROG.
B
PROG.
B
2
5 to 15
sec
4
A
7