Handling Instruction For Consumable And Printed Output - Hiti P310W Manual Del Usuario

Chapter 1. Important Safety Instruction
Handling Instruction for Consumable and Printed Outputs
In handling the ink ribbon, paper and printed outputs, please pay attention to the followings;
Paper Handling
Use only the paper specified by HiTi.
Store the paper flat.
Store the paper in a dry and dark place to avoid direct sunlight.
(Temperature less than 30℃, Humidity: lass than 60%).
Do not touch the paper surface before printing to avoid fingerprints.
Ink Ribbon Handling
Use the ink ribbon specified by HiTi.
Store the ink ribbon in cool place to avoid sunlight.
(Temperature less than 30℃, Humidity: less than 60%).
Printout Handling
Store the ink ribbon in cool place to avoid sunlight.
Store the printout way from the organic solvent or fluid which may change or deteriorate
the colors.
When abandon the ink ribbon, please handle it as harmful industrial waste.
Please take caution while handling the paper to prevent injure to the hands or paper-cut.
FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
HiTi P310W user manual
1 - 3