sunjoe PPG400 Manual Del Operador página 5

If the power station overheats during the charging
process, the power station will resume working once the
temperature has dropped and the internal battery has
cooled down.
If the power station overheats during the discharging
process, turn off the power station and wait until the
power station cools down. Then restart the power station
to resume usage.
Charging Operations
This power station must be fully charged before use or storage.
Check the LCD screen for the remaining power in the built-
in battery. If the power drops to 20% or less, stop using the
power station and charge it as soon as possible.
The power station can be charged by:
• The included AC charger
• 12V DC car charging cable (sold separately)
NOTE: Do not use the power station to power/charge other
devices while the power station is being charged.
Follow the instruction below to charge the power station.
AC CHARGER
1. Check whether the mains voltage is the same as that
marked on the AC charger. Then, plug the AC charger into
an electrical wall outlet.
2. Turn off the power station and remove all loads connected
with the power station. Connect the charger plug into the
charging socket to start charging (Fig. 2).
Fig. 2
AC Charger
Charging
socket
3. During the charging process, the battery charging level
indicator on the LCD screen will light up and flash to
indicate the charging process. The indicator light on the
AC charger adapter will light up in red (Fig. 3).
LCD Screen
Fig. 3
(charging mode)
Light
indicator
(red)
4. It will take approximately 12 hours to fully charge the
power station. When charging is complete, the battery
charging level indicator will stop flashing and light up solid.
Additionally, the light indicator on the AC charger will turn
green. Unplug the charger when the power station is fully
charged (Fig. 4).
LCD Screen
Fig. 4
(charged mode)
Light
indicator
(green)
CAR CHARGER
1. While the car is running, use the optional 12V DC car
charging cable (PPG-CARCHRG sold separately) to
connect the power station to the car's 12V DC outlet
(Fig. 5). Charging will start as soon as the power station is
connected.
Fig. 5
LCD Screen
(charging mode)
12V DC outlet
2. It will take approximately 6 hours to fully charge the power
station. Disconnect the charging cable when the power
station is fully charged.
5