Maintenance/Cleaning; Storage; Waste Disposal And Environmental Protection - Grizzly EHS 550 T Traducción Del Manual De Instrucciones Original

in a flat shape, roof shape or rounded
shape
3. Trim young plants to the required
shape. The main growth should re-
main undamaged until the hedge has
reached the planned height. All other
shoots are lopped off to half size.
Care of Free-Growing Hedges:
Free-growing hedges are not shaped when
cut, although they must be regularly main-
tained so the hedge does not become too
high.

Maintenance/Cleaning

Repair and servicing work not
described in this manual should
always be carried by our Service
Centre. Use only original parts.
Do not use any cleaning agents or
solvents. These could cause irrepa-
rable damage to the equipment.
Chemical substances can attack
the plastic parts of the equipment.
Pull out the power plug before car-
rying out any work on the equip-
ment.
Wear gloves while handling the
blades.
Carry out the following maintenance and
cleaning work regularly. This will guarantee
a long and reliable service life.
• Before each use, check the hedge
trimmer for obvious defects such as
loose, worn or damaged parts. Check
the secure seating of the bolts in the
cutter bar.
• Check coverings and safety devices for
damage and correct seating. Replace
these where necessary.
• Keep the ventilation slots (
motor housing (cutting head) (
the device clean. Use a damp cloth or
a brush to do this. Do not wash down
the equipment with water, or submerge
it in water.
• Always keep the equipment clean.
After using the equipment, it is im-
perative to:
- Clean the blade
(with an oily cloth);
- Oil the blade shaft
with an oil can or
spray.
• Slight notches on the blades can be
evened out. For this, sand down the
blades with an oil stone. Only sharp
blades can cut properly.
• Blunt, bent or damaged blades must
be changed.

Storage

• Keep the trimmer in the blade guard
supplied, in a dry place and out of
reach of children.
• Store the unit horizontally or assured
against falling over. Bring the cutting
unit in storage location.
Waste Disposal and Envi-
ronmental Protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.
Electrical machines do not belong
in domestic waste.
• Take the equipment to a waste dis-
posal site. The plastic and metal parts
that are used can be separated out
into pure grade, which allows recycling.
GB
4) and
3) of
27