UNILITE PS-HDL2 Guia De Inicio Rapido

FEATURES
• High power 200 Lumen white Cree® LED
• 2 x 5mm white LEDs for flood light
• 3 x AAA alkaline batteries included
• IPX6 water resistant
• Easy push micro switch
• 45° rotational head
• Ultra-smooth reflector for long distance beam
• Fully adjustable non-slip silicone headband
• 3M™ VHB™ adhesive helmet mount included
BATTERY - 3 x 1.5v AAA Alkaline Energizer Batteries (included)
WEIGHT - 88g (including batteries)
DIMENSIONS - Headlight: 47 x 62 x 37mm
OPERATION
Press
SPOT BEAM
HIGH
Press
SPOT BEAM
MEDIUM
Press
SPOT BEAM
LOW
Press
SPOT BEAM
SOS
WHEN 'ON' IN EITHER SPOT OR FLOOD MODE, PRESS AND HOLD TO SWITCH
TO THE OTHER MODE
[If left in any mode for over 3 seconds, the next press will turn off]
www.unilite.co.uk
Press
FLOODLIGHT
HIGH
Press
FLOODLIGHT
LOW
Press
FLOODLIGHT
STROBE
Press
OFF
ANSI FL1 Standard
HIGH
MEDIUM
LOW
SOS
HIGH (FLOOD)
LOW (FLOOD)
STROBE (FLOOD)
BATTERY INSTALLATION
Pull the head part away
from the bracket
Install 3 x AAA alkaline batteries according to the polarity markings
ADVICE & IMPORTANT INFORMATION!
Only use high-quality Alkaline batteries or Ni-MH rechargeable batteries.
DO NOT USE rechargeable LITHIUM batteries, these will damage your headlight as they exceed rated
voltage.
Do not use batteries of different brands or mix old and new batteries. Please recycle used batteries
responsibly.
Battery life is affected by different battery brands, different ambient temperatures and different
lighting modes.
If the batteries are damaged, fluids can leak out. AVOID contact as this can lead to skin irritation and/
or burns. If skin contact occurs, rinse thoroughly with water. If irritation persists, seek medical advice.
Seek immediate medical assistance if battery fluid comes into contact with the eyes.
Do not look directly at the LED.
Do not use this product in extreme cold or hot environments (below -30°C or above 60°C).
Children under 12 years of age should only use the product with adult supervision.
This product is water resistant to IPX6 – DO NOT SUBMERGE. If the product has been affected by
damp, remove the batteries and leave the unit open and allow to dry out completely before using.
Take care not to let the lens come into contact with hard/sharp objects, damage to the lens will
affect light output.
If you are not using the product for long periods of time (3 weeks or more), remove batteries to
prevent battery leakage and battery depletion.
If the batteries are installed and the headlight does not work, try checking for the following: (1) Press
the switch button several times. (2) Check that the batteries are inserted the correct way around
according to polarity markings. (3) Check there is no debris on the contacts that might affect the
battery connection. (4) Check there is no water or dampness in the light, if so, allow it to fully dry
out and try again. If the product has been subjected to excessive moisture/water the warranty may
be void.
Children under 12 years of age should only use the product with adult supervision.
This product has a 1 year standard warranty (or extended to 2 years once registered online at WWW.
UNILITE.CO.UK) against manufacturing faults and defects. It does not cover normal wear and tear,
modifications, accidental damage or poor maintenance. Unilite warranties do not cover battery leaks
or the use of incorrect chargers and cables that can damage batteries.
Do not dispose of this device in normal household waste. It must be disposed of via an authorised
disposal centre or at your local waste disposal unit.
Please reuse or recycle packaging where possible.
Keep these instructions for future reference or for subsequent possessors.
PS-HDL2
200
95 M 5 H
Lumens
80
60 M 10 H
Lumens
15
120 H
23 M
Lumens
145 H
30
30 H
6 M
Lumens
10
100 H
4 M
Lumens
185 H
Lift clip gently to open
battery compartment