Denver MLC-3201MK2 Manual Del Usuario página 5

Section 3: Mount Installation
This monitor ONLY includes screws which may be used when attaching the
monitor to a VESA 75x75mm type mount. No VESA mount or mounting accessory
is included.
1. Open the package, take out the product with foam still attached, and gently place
it on a desktop or table. If the monitor is attached to the stand, remove the stand.
2. Take out the two parts of the stand, remove the foam covering the back of the
monitor, and press the button to remove the stand plate.
3. Remove the original screws x 4 (
then use the NO. 2 screws provided to secure the rear panel.
4. Follow the directions received with your VESA mount stand or accessory and install
the monitor on the wall or fixture as desired. Remember to use the included NO. 2
screws when attaching anything to the back of the monitor. Refer to the image
( ) for correct screw placement when attaching the monitor to a mount.
2
1
-
Use only the NO. 2 Screws (30 mm x 2 pcs, 26mm x 2 pcs) provided with
this type of installation.
- Do not discard the original screws as these may be needed for future use.
) from the opening in the back of the monitor,
1
2
Mount
(Not Included)
Eng-5
Stand Base
Stand Stem
Foam
Stand
Plate
Button
Use
the
30mm
NO.
2
Screws
x
2
Use
the
26mm
NO.
2
Screws
x
2