Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package and hardware contents
list. If any part is missing or damaged, do not attempt to assemble the product. Contact Customer Service for replacement
parts.
Estimated Assembly Time: 30 minutes
Tools required for assembly (not included): Tape Measure, Phillips Screwdriver, Hammer, Electric Drill, Drill Bits, Level
Please follow all local electrical codes and consult an electrician when wiring this product.
WIRING DIAGRAM
Installation may vary depending on how the previous mirror was installed and the presence of the power source. Supplies necessary for installation
of your new mirror are not all included; however, most are available at your local home improvement or hardware store.
*House wires may vary in color. Please be sure to verify actual house wires with a certified electrician before installation.
INSTALLATION INSTRUCTIONS
WARNING: Turn off power at circuit breaker or remove fuse
before attempting installation.
1. Choose to mount the mirror (A) in either a vertical (1-A) or
horizontal (1-B) orientation. Once the orientation is chosen,
measure the distance between the center of the keyholes
in the mounting bracket as shown in the vertical (1-A) or
horizontal (1-B) orientation.
Refer to the rough-in drawings shown on pages 5 and 6 for details
on the distance between the mounting points on the wall.
2. After measuring the distance between the keyholes on
the mirror (A), mark the mounting points on the wall in the
appropriate spots. These marks should be the same distance
apart as measured in step 1. Use a level to ensure the mounting
points are straight.
3. Using a 7/32 in. drill bit (not included), drill holes where marked
in step 2 and insert the drywall anchors (BB).
Hardware Used
BB
Drywall anchor
Mirror
white
green
black
neutral
ground
live
1
2
3
x 4
3
House
Electrical
Wires*
white
green
black
BB
Publicidad
Tabla de contenido
