Lightair IonFlow Serie Manual De Instrucciones página 39

This air cleaner complies
with the federal ozone
emissions limit.
ARB CERTIFIED
FOR INDOOR
USE ONLY
R 39624
RoHS
LightAir AB | Mariehällsvägen 37F | 168 65 | Bromma, Sweden | info@lightair.com | www.lightair.com
CERTIFIED ACCORDING TO UL 867
This appliance complies with the European Directives for electro-
magnetic compatibility (EMC) 2014/30/EU and its revisions, as
well as Low Voltage Directive (LVD) 2014/35/EU and its revisions.
This appliance complies with the WEEE-Directive 2012/19/EU on
the disposal of electrical and electronic equipment (WEEE).
This product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, recycle it respon-
sibility to promote the sustainable reuse of material resources.
To return your used device, please use the return and collection
systems or contact the retainer where the product was purchased.
They can take this product for environmental safe recycling.
WARNING: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B ISM equipment, pursuant to Part 18 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• REORIENT OR RELOCATE THE RECEIVING ANTENNA.
• INCREASE THE SEPARATION BETWEEN THE
EQUIPMENT AND RECEIVER.
• CONNECT THE EQUIPMENT INTO AN OUTLET
ON A CIRCUIT DIFFERENT FROM THAT TO WHICH
THE RECEIVER IS CONNECTED.
• CONSULT THE DEALER OR AN EXPERIENCED RADIO
TV TECHNICIAN FOR HELP.
Electrical rating: 12VDC (with class II AC/DC adaptor, input:
100 – 240VAC 50/60Hz 0.4A max.,
output: 12VDC 600 – 1000mA)