Publicidad
A-FRESCO
EN
IMPORTANT SAFETY INSTRUCTIONS
1). Read & Retain these Instructions carefully before installing or operating this product.
2). Comply with Warnings: All warnings and instructions for these products should be adhered to.
3). Unpacking: On unpacking your product please check carefully for any signs of damage that may have occurred whilst in transit
from the Laney factory to your dealer. In the unlikely event that there has been damage, please re-pack your unit in its original carton
and consult your dealer. We strongly advise you to keep your original transit carton, since in the unlikely event that your unit should
develop a fault, you will be able to return it to your dealer for rectification securely packed.
4). Amplifier Connection: In order to avoid damage, it is advisable to establish and follow a pattern for turning on and off your
system. With all system parts connected, turn on source equipment, CD/MP3 players, mixers/recorders, etc, BEFORE turning on your
guitar amplifier. Many products have large transient surges at turn on and off which can cause damage to your speakers. By turning on
your guitar amplifier LAST and making sure its level control is set to a minimum, any transients from other equipment should not reach
your loud speakers. Wait till all system parts have stabilised, usually a couple of seconds. Similarly when turning off your system always
turn down the level controls on your guitar amplifier and then turn off its power before turning off other equipment.
5). Servicing: Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way,
such as when the DC Power Supply is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been dropped.
6). Placement: This electrical apparatus should not be exposed to dripping or splashing and
care should be taken not to place objects containing liquids, such as vases, upon the apparatus.
Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus
(including amplifiers) that produce heat. Do not block any of the ventilation openings.
Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with
the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to
avoid injury from tip-over.
7). When using the DC power Supply: Only use the approved DC power supply provided by
the manufacturer. Rating
24VDC 1.5A. Protected by a 125°C thermal fuse.
Protect the power cord on the DC power Supply from being walked on or pinched, particularly at plugs, convenience receptacles,
and the point they exit from the apparatus.(See notes on using the DC Power Supply page 5).
8). Battery Pack:
battery pack only. (See notes on fitting and replacing batteries page 8).
Use the A-FRESCO Li-Ion
9). Sound Levels: Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably in
susceptibility to noise-induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for
a sufficient time.
The U.S. Government's Occupational Safety and Health Administration (OSHA) has specified the following permissible noise level
exposures: According to OSHA, any exposure in excess of the above permissible limits could result in some hearing loss. Earplugs
or protectors to the ear canals or over the ears must be worn when operating this amplification system in order to prevent a
permanent hearing loss, if exposure is in excess of the limits as set forth above. To ensure against potentially dangerous exposure
to high sound pressure levels, it is recommended that all persons exposed to equipment capable of producing high sound
pressure levels such as this amplification system be protected by hearing protectors while this unit is in operation.
10). Maintenance: Clean only with a dry cloth.
11). Pole Stand: Don't over-extend poles/tripods; ensure at least 4 x the diameter is still inside the outer pole.
Make sure the legs have a good splay on the tripod, but do not obstruct doorways or other access-ways. Ensure the unit is stable
and cannot fall over.
3
Publicidad
