Technical Data; Troubleshooting - Lelit PG029N35 Instrucciones De Uso

PG029N35

TECHNICAL DATA:

Adjustable iron thermostat set from 0°C to 215°C
Bimetallic safety iron thermostat with manual reset at 275°C
Heating element:800W - 230V
Boiler power : 2000W (2 x 1000W)
Working pressure: 3,5 bar
Max. pressure: 5,5 bar
Tank nominal capacity: 3,5 litres
TROUBLE SHOOTING:
PROBLEM
It may happen that, while filling
the tank, some water spills over
Does steam go out
the cap and flows inside the
from the boiler?
boiler
material
While filling the tank you may
have poured too much water into
Does the steam iron
leak steam mixed it.
with water?
The iron plate has to be hot
before the steam passage
The iron button might be off
Does not the iron
The boiler button might be off
give off steam?
The water might be used up (the
low water light indicator might be
on)
The ironing board cover might
not be able to absorb the steam
completely
Does the ironing
board wet?
The
mixed
spraying some steam on a dry
cloth)
Maybe there is some dirty water
Does the iron leak
might have gone into the tank
dirty water?
and it is given off from the iron.
The inserted data and pictures can be subject to changes without previous notice for the improvement of the
machine's performances.
EXPLANATION
wetting the insulating
steam iron leaks steam
with water (check
In order to solve the problem, we suggest using the
machine as usual so to dry up the insulating material
through the heat of the machine. In case you still
have this problem after one working hour, please
contact the service shop
The problem will go on until the excess water is
emptied. Keep the steam button depressed until the
water in the tank is at the correct level.
Please check that the temperature knob is on the
right position: "cotton °°°)"
Push the iron button the red le comes on; wait for 4
minutes so that the iron plate warms
Push the boiler button the red led comes on: wait for
10 minutes so the boiler produces steam.
Fill it to the required level following the instructions
carefully.
You might use a thicker cover (or two covers) so to
create a thicker surface to absorb the steam better. In
case you are using a vacuum table, switch on the
vacuum function each time you are using the steam
by
See # 2
Fill the empty tank with 1 liter of water, screw the cap
up, shake it, open the cap and empty the tank.
Repeat the action until the water is cleaned. We do
not recommend the use of any additive to pour in the
tank. Before ironing again spray some steam on a
cloth until clean steam comes out.
SOLUTION
English
Pag. 5