Set Up Instructions; Connecting Instructions - BRINKMAN Coach Manual Del Propietário

INS_828-0301-0_Coach
Inspect lights, transformer and power cords to ensure that they are undamaged.
Step 1
Lay out the low voltage lights in predetermined area. Cords allow
for a maximum spacing of 10 feet between lights. Do not install
transformer or bury cable yet.
Step 2
Place each light in the ground so only the stake is buried. (See Below)
WARNING: Only use cables provided with
product. Do not splice cables. Coil excess cable
between lights around stakes and bury.
WARNING: Once connected, bury cable a
minimum of 3 inches and maximum of 6 inches
below ground surface. Do not bury cable in material
that may damage the cable.
WARNING: Prior to digging ground to burying
cable, be sure that no other cables are located in the
same area. Contact your local authority to determine
what cables (telephone, electric, gas) may be buried
Stake
underground.

CONNECTING INSTRUCTIONS

NOTE: DO NOT PLUG IN THE TRANSFORMER UNTIL LIGHTS
HAVE BEEN SET UP AND CONNECTED.
Step 1
Remove dummy cap on the transformer terminal
connector and set aside. Starting from transformer,
connect each male and female connector to each
other throughout light strand.
Step 2
Insert the male connector into the female connector
using the key and key slot as a guide.
Step 3
Once inserted, turn ribbed locking ring clockwise
until tight.
Step 4
Attach the dummy cap (that was set aside from Step 1)
to the last connector at the end of light strand.
Step 5
Install transformer (see next page). Check that all lights
are working properly before burying cable.
11/3/08 5:48 PM Page 3

SET UP INSTRUCTIONS

READ ALL WARNINGS AND INSTRUCTIONS BEFORE PROCEEDING.
Key
Female Connector
WARNING: When connecting the cables, be sure the
o-ring is present on all male connectors. Hand
screw tightly together to get a proper seal. Do not
over tighten.
Key Slot
Ribbed Locking Ring
Male Connector
Dummy Cap
2