Joycare JC-221 Manual De Instrucciones página 5

STERILIZATION MODE
- Fill the heating base with 70ml water
- Place the tank on the heating base and place the bottle rack inside the former. Warning: place the appliance on a horizontal surface.
- Remove (or unscrew) teats and place feeding bottles in the rack (upside down). Such arrangement allows steam to correctly and evenly penetrate
inside the bottles.
- Place the teat holder attachment (also suitable for other small accessories to be sterilized) on top of the rack. Then place accessories and teats on
the holder.
- Plug appliance in and select the
(duration approx 9 minutes). The appliance turns off automatically once the cycle is over
- It is advisable to unplug the appliance once the sterilization cycle is completed.
Notes: The appliance becomes very hot during, and immediately following, the sterilization process. To avoid burns do not touch internal parts or move the
appliance with the hands. Always allow appliance to cool down (a few minutes)
Note: bottles and accessories must be thoroughly washed and rinsed with plenty of fresh water before sterilization.
BOTTLE WARMER MODE
Fill the heating base with distilled water (see following table for correct dosage).
Milk volume (ml) contained in feeding bottle
240
150
- Place the feeding bottle warmer lid on the heating base.
- Insert the bottle (filled with milk) through the hole in the lid.
- Then plug appliance in and select the
milk temperature reaches 40°C and the appliance switches off automatically.
- Unplug the appliance.
Notes: always test milk temperature before feeding it to a baby.
Appliance also suitable for defrosting feeding bottles straight from the freezer.
It is advisable to retrieve the heated feeding bottle only when the warm-up cycle is complete and the appliance has automatically switched off.
BABY FOOD POT WARMER MODE
- Remove any attachment present on the heating base.
- Fill the heating base with 100ml water
- Place the baby food warmer tray attachment on the heating base
- Place the baby food pot on the tray attachment
- Fasten the appliance by placing both the bottle warmer lid and the appliance lid on the tray
- Then plug the appliance in and select the
lasts approx 7 minutes, the appliance then turns off automatically.
Note: always test milk temperature before feeding it to a baby.
CITRUS SQUEEZER MODE
- Place the heating tray attachment on the heating base.
- Place the citrus squeezer attachment on the heating tray
- Cut an orange or a lemon into two pieces to squeeze
- The citrus squeezer attachment is manually operated (hence the appliance must not be plugged in).
VEGETABLE COOKER MODE (CARROTS, POTATOES, ETC...)
The appliance is also designed for steam cooking vegetables. Cooking time varies according to quantity, type and temperature of the food in the basket.
- Place the appliance on a horizontal and stable surface.
- Remove any attachment present on the heating base.
- Fill the heating base with 180ml water
- Put the large tank on the heating base
- Clean the food (carrots or potatoes, etc.) and cut into small pieces
- Place the cut food inside the tank and set the timer according to desired degree of steam cooking.
- Rotate the command dial to select the
- Cooking cycle duration varies from 12 to 15 minutes
icon by rotating the command dial. The LED indicator will turn green. The sterilization cycle will start
Initial feeding bottle temperature
25°C
5°C
25°C
5°C
icon by rotating the command dial. The LED indicator will turn green. The LED indicator turns off once
icon by rotating the command dial. The LED indicator will turn green. The pot warming process
icon.
5
Required quantity of water
About 15 ml
About 30 ml
About 10 ml
About 26 ml