Conceptronic C150BRS4 Manual Del Usuario página 31

3. Renew the IP address of your computer with the following commands:
- „IPCONFIG /RELEASE‟
- „IPCONFIG /RENEW‟
If above steps do not solve the IP address issue, you can reset the device to the factory default settings
with the WPS/reset button on the back of the device.
Press and hold the WPS/reset button until the status LED turns off (about 15 seconds). This will reboot the
router and load the factory default settings into the router. When the power LED burns steady again,
repeat step B to renew the IP address.
Note: If the problem remains, check if all cables are connected in the correct way. The WAN port
should be connected to the modem and the LAN port to the computer. Connecting them in the
wrong way will also result in an incorrect IP address.
: this will release the incorrect IP address
: this will renew the IP address
3
3
ENGLISH
31