Everbilt 1005129161 Guía De Uso Y Cuidado página 15

Installation (continued)
5.
Installing the flush valve
A. Put the base (A2) into the installation hole of the tank and adjust overflow pipe (A4) position. Make
sure that the position of the overflow pipe is consistent with the direction observed in 2B (please
make sure that the overflow pipe and the base do not touch the inner wall of the water tank and other
water parts when adjusting).
B. Tighten the lock nut (A3). It is recommended to tighten the nut 3/4 turn. Do not overtighten
when tightening the nut to avoid damaging the water tank, bowl, and screw teeth.
C. Reinstall valve body (A1) on the base (A2), rotate the valve body (A1), and adjust the positions of
the full and half flush buttons to ensure the same direction as viewed in 2B.
D. Install the rubber gasket (D). The rubber gasket should be placed flat to ensure there is no leakage
between water tank and bowl.
1
A2
A3
6.
Reinstalling the water tank
A. Connect the bolts (C) with rubber gaskets, flat washers,
washers, and nuts onto the bolt holes of the water tank and
tighten.
NOTE: Do not overtighten to avoid damaging
water tank.
B. Place the water tank on the bowl, and tighten in place using
the second set of washers and nuts included with the bolts (C).
NOTE: Do not overtighten to avoid damaging
water tank and bowl.
C. Insert the refill tube into the white cap of the overflow pipe (A4).
NOTE: The rim of the refill tube should be higher
than working water level to avoid water leakage.
2
A4
A1
A2
8
3
D
1
Bolt Gasket
C
Installation
sequence
2
3
A4
Water Tank
Rubber Washer
Washer
Nut
Water Tank
Bowl
Washer
Nut