Braven FLYE SPORT Manual Del Usuario página 4

W A R N I N G S , C A U T I O N
& L E G A L I N F O R M A T I O N
To reduce the risk of fire or electric shock, do not expose
the Braven Earbuds to rain or moisture while charging.
The Braven Earbuds should not be exposed to dripping or
splashing, and objects filled with liquids, such as vases,
should not be placed on or near it while being charged or
charging other devices. As with any electronic products,
use care not to spill liquids into any par t of the product.
Liquids can cause a failure and/or a fire hazard. The power
supply must be used indoors only. Make no modifications
to the product or accessories. Unauthorized alterations
may compromise safet y, regulator y compliance, and
system per formance, and will void the warrant y. Do
not place any flame sources, such as lighted candles,
on or near the BRAVEN Earbuds. The BRAVEN Earbuds
contains small par ts that may be a choking hazard and
is not suitable for children under age 3. Do not continue
charging the bat ter y if it does not reach full charge
within the specified charging time. Overcharging may
cause the bat ter y to become hot, rupture, or ignite. If you
see any heat deformation or leakage, properly dispose
of the bat ter y. Do not at tempt to charge the bat ter y in
temperatures outside the range of 32°-104°F (0°-40°C).
If the bat ter y begins to leak, do not allow the liquid to
come in contact with your skin or eyes. If contact has
been made, wash the af fected area with plent y of water
and seek medical at tention immediately. Do not expose
the product or bat ter y to excessive heat, including direct
sunlight or fire and storage or use inside cars in hot
weather, where it can be exposed to temperatures in
excess of 115°F (60°C). Doing so may cause the bat ter y
and power supply to generate heat, rupture, or ignite.
Using the product in this manner also may result in a
loss of per formance and a shor tened life expectancy.
Extended exposure to direct sunlight may damage the
external appearance and material qualities. Do not step
on, throw, or drop bat teries or the power supply or device,
or expose them to a strong shock. Do not pierce, crush,
dent, or deform the bat teries or power supply in any way.
If either becomes deformed, properly dispose of it. Do
not shor t-circuit bat teries. Do not at tempt to ser vice
the BRAVEN Earbuds yourself. Opening or removing
covers may expose you to dangerous voltages or other
hazards and will void the manufacturer's warrant y. To
prevent risk of fire or electric shock, avoid overloading
wall outlets, extension cords, or integral convenience
receptacles. Your Bluetooth device (mobile phone,
music player, tablet, laptop, etc.) must suppor t the A2DP
Bluetooth profile in order to work wirelessly with your
new BRAVEN Earbuds. The A2DP profile is suppor ted
by most recent mobile products with built-in Bluetooth
capabilit y. Please refer to your device's user manual for
details and instruction regarding the Bluetooth profiles
it suppor ts.
This device complies with par t 15 of the FCC Rules.
Operation is subject to the following t wo conditions:
(1) This device may not cause harmful inter ference, and
(2) this device must accept any inter ference received,
including inter ference that may cause undesired
operation.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to par t 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
inter ference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful inter ference to radio
communications. However, there is no guarantee that
inter ference will not occur in a par ticular installation.
If this equipment does cause harmful inter ference to
radio or television reception, which can be determined by
turning the equipment of f and on, the user is encouraged
to tr y to correct the inter ference by one or more of
the following measures:— Reorient or relocate the
receiving antenna. — Increase the separation bet ween
the equipment and receiver. — Connect the equipment
into an outlet on a circuit dif ferent from that to which
the receiver is connected. — Consult the dealer or an
experienced radio/ T V technician for help.
CAUTION: Any changes or modifications not expressly
approved by the par t y responsible for compliance could
void the user's authorit y to operate the equipment.
FCC RADIATION EXPOSURE STATEMENT: This device
complies with FCC radiation exposure limits set for th for
an uncontrolled environment.
This device complies with Industr y Canada license-
exempt RSS standard(s). Operation is subject to the
following t wo conditions:
(1) this device may not cause inter ference, and
(2) this device must accept any inter ference, including
inter ference that may cause undesired operation of the
device.
Under Industr y Canada regulations, this radio transmit ter
may only operate using an antenna of a t ype and
maximum (or lesser) gain approved for the transmit ter by
Industr y Canada. To reduce potential radio inter ference
to other users, the antenna t ype and its gain should be so
chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessar y for successful
communication.
Lithium Bat ter y installed is not intended to be replaced
by the USER.
CAUTION: Danger of explosion if bat ter y is incorrectly
replaced. Replace only with the same or equivalent t ype.
Where the MAINS plug is used as the disconnect device,
the disconnect device shall remain readily operable.
The device meets the exemption from the routine
evaluation limits in section 2.5 of RSS 102 Issue 5 and
compliance with RSS-102 RF exposure, users can obtain
Canadian information on RF exposure and compliance.
Correct Disposal of this product. This marking
indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent
possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources.
To return your used device, please use the return and
collection systems or contact the retailer where the
product was purchased.
This product complies with California
Energy Commission ef ficiency standards for consumer
bat ter y chargers.
This device complies with Industr y Canada license-
exempt RSS standard(s). Operation is subject to the
following t wo conditions: (1) this device may not cause
inter ference, and (2) this device must accept any
inter ference, including inter ference that may cause
undesired operation of the device
BATTERY SAFETY: Store the por table backup bat ter y in
a cool, dr y place, and avoid exposure to moisture, high
temperatures, open flames, chemicals, or corrosive
materials. Do not shor t circuit, open, disassemble,
modif y, repair, or replace any par t of the por table
backup bat ter y. Doing so may cause the bat ter y to
ignite, explode, leak, or become excessively hot, causing
personal injur y. Avoid excessive impact, physical
shock, or vibration as they may damage the por table
backup bat ter y. Inspect the case carefully before each
use, especially af ter any drop, bump or other impact,
to identif y any sign of damage. If the por table backup
bat ter y becomes damaged, swells, leaks, overheats, or
functions abnormally, immediately discontinue use and
contact Incipio. Avoid all contact with contents from a
leaking bat ter y. The por table backup bat ter y is designed
to be charged many times. Use the included micro USB
cable and an approved bat ter y charger. Never use a
modified or damaged bat ter y charger. Do not reverse
charge or reverse connect the bat ter y. Please note the
bat ter y will normally be warm during charging. Recycle
or dispose of the por table backup bat ter y's bat teries
properly and in accordance with applicable federal,
state and local laws and regulations. Do not dispose of
bat teries in the trash or fire.
Due to the isolating characteristics of these headphones
do not use while driving, riding a bike or where vehicular
traf fic is present, or in any other activit y where failure
to hear surrounding sounds could be dangerous. Use
of these headphones at excessive volumes may cause
permanent hearing damage. Always turn the volume
down before use. Take caution in regards to inser ting
objects into ear canal, use at own risk.
Product name: BRAVEN FLYE SPORT
Model number: Black: BB12BBB -- White: BB12W W W --
Silver/Green: BFSSG -- Gray/Red: BFSGR
Manufacturer: BRAVEN LC.
Accessories included for use: Micro-USB to USB charging
cable, small, medium and large earbud tips, waterproof
carr y pouch.
Hardware version 1.0
Frequency Bands: 2.402GHZ – 248GHZ
Maximum output power: 4dbm
E N G L I S H | 4