Follow these regulations carefully to avoid harm to the operator and damage to the machine .
Follow these regulations carefully to avoid harm to the operator and damage to the machine
Follow these regulations carefully to avoid harm to the operator and damage to the machine
Follow these regulations carefully to avoid harm to the operator and damage to the machine
r Read the labels on the machine carefully. Never cover them for any reason and immediately replace them if they are damaged
r The machine must be used exclusively by authorized and trained personnel
r When operating the machine be careful of other persons and of children in particular
r Never mix different types of detergents: this could generate noxious gases
Never set containers of liquid on the machine
r Machine storage temperature must be between -25 ° C and +55 ° C
Operating conditions: room temperature between 0 ° C and 40 ° C with relative humidity between 30 and 95%.
r Never use the machine in an explosive environment
Never use the machine to transport goods
r Never use acid solutions which could damage the machine and/or persons
Avoid running the brushes with the machine stopped: this could damage the floor
Never suck flammable liquids
Never use the appliance to collect dangerous powders.
r Use a powder fire extinguisher in case of fire. Do not use water
r Do not hit against shelving or scaffolding when there is a danger of falling objects
r Suit operating speed to traction conditions
r Do not use the appliance on surfaces with a slope higher than the one indicated on the name-plate.
Whenever you park the machine remove the key and apply the parking brake
Whenever the machine has operating troubles make sure these are not due to insufficient ordinary maintenance. If this is not
the case then enquire with your nearest COMAC
r When replacing machine parts always ask for ORIGINAL spare parts from your Authorized COMAC
r Use only original COMAC
COMAC polishing pads
COMAC
COMAC
Immediately engage the emergency lever in case of danger (connector placed below the machine operator)
Always cut off the electric power supply to the machine whenever maintenance is performed
r Restore all electrical connections after terminating any maintenance procedures
Never remove guards that require tools for removal
r Never wash the machine with direct or pressurized jets of water or with corrosive substances
r Have your nearest COMAC
COMAC service center check the machine every 200 operating hours
COMAC
COMAC
r Before you use the machine make sure that all doors and covers are positioned as shown in this operating and maintenance
manual
r Dispose of consumables in accordance with currently applicable laws and codes
r When, after years of precious work, your COMAC
properly disposed of: they contain oils, batteries and electronic components. Remember that the machine itself was built
using totally recyclable materials
GENERAL SAFETY REGULATIONS
GENERAL SAFETY REGULATIONS
GENERAL SAFETY REGULATIONS
GENERAL SAFETY REGULATIONS
COMAC service center
COMAC
COMAC
COMAC machine is ready to be retired all of its component materials must be
COMAC
COMAC
27
COMAC dealer and/or Retailer
COMAC
COMAC