Maintenance; Emptying The Dirt Cup; How To Clean - Samsung SU-2900 Serie Instrucciones De Operación

Familiarize yourself with these home maintenance tasks as proper use and care of your cleaner will ensure continued
cleaning effectiveness.
When to empty the Dirt Cup
The dirt cup needs to be emptied when the dirt reaches the "Full" line on the side of the Cup.
If more dirt than this accumulates, your cleaner will not operate effectively.
Note: All new carpet has loose fibers which can fill the Dirt Cup quickly while vacuuming.

Emptying the Dirt Cup

Disconnect cleaner from electrical outlet.
3-1
Unlock
Position
Slide the Cyclone-Lever to the
"Unlock" position.
Grasp handle and pull the Dirt
Cup straight out to remove from
Vacuum.
Cleaning the Pre/Post-motor Filter
3-4
Pre-Motor
Filter

How to clean

Disconnect cleaner from
electrical outlet.
The Pre-Motor Filter protects the
Motor from debris.
It is located underneath the Dirt
Cup and Filter Cup in the
Center of the round part of the
Cyclone-Lever.
Remove the small round Filter
and any debris on top of it. Rinse
well under warm water, then air
dry thoroughly before replacing.
M a i n t e n a n c e
3-2
Full Line
Lock
Position
Empty dirt into garbage container.
Put the Dirt Cup back in the
vacuum and slide the lever to the
"Lock" position.
3-5
Post-Motor
Filter
The Post-Motor Filter assists in the
filtation process to return clean
air to the room. It is located
behind the door on the front of the
Cleaner. When the filter becomes dirty,
open the door, remove the filter and
shake the dust off the filter.The Post-
Motor Filter is non-washable therefore
do not wash it in water.
Replace the door by inserting
the tabs on the left side and
snapping the right side into place.
Do not operate cleaner without
Either the Pre-Motor Filter or
Post-Motor Filter in place.
4
3-3
Cleaning The Circular Filters.
Grasp the Filter Cup located at
the bottom of the Dirt Cup and twist
counterclockwise to unlock and
remove.
3-6
Grasp the Circular Filters and twist
to unlock Pull straight up to remove.
Separate the Outer foam and Inner
pleated Circular Filters.
Wash each individually by hand
in warm water. Mild detergent may be
used if desired. Rinse well, then air dry
Thoroughly dry before putting them back
together and replacing in the Filter Cup
The Filter Cup may be washed In warm
water with a mild detergent. Make sure it
is completely dry before reassembling
with fliters.