Visual Inspection - Atlas Copco G2417-S180 Manual Del Usuario

G2417-S180
Setting-up instructions
WARNING Overspeed can result in serious injury or death
The maximum permissible speed as marked on the tool must not be ex-
►
ceeded
Testing of the die grinder should only be carried out by professional techni-
cians. The technicians must be authorized to test this type of tool and to operate
a pneumatic system in accordance with national directives.
• The free speed of the machine shall be checked every day and whenever the
machine has been serviced. This check should be carried out with the grind-
ing equipment detached
• Use a pressure regulator to avoid excessive air pressure which may cause
overspeed
• Connections and air hose must be in good condition
Legend to page 2
A Check free speed
Maximum 18000 r/min (rpm)
B Maximum air pressure: 6.3 bar ( 90 psig)
Operating instructions

Visual inspection

Tool and accessories
Inspect the tool and its parts visually before use.
• Collet holder.
• Throttle lever.
• Lever catch.
Look for any damages or oil leakage that can compromise the safety of the tool.
Air installation
Inspect the air installation from the supply point to the tool visually before
use.
• Hose
• Couplings
• System pressure
• Air filter
Look for any damage that can compromise the safety of the tool.
Precautions
Read the General Safety Instructions before using the die grinder.
EN
© Atlas Copco Industrial Technique AB - 9836 9904
Operation
9