Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
DOOR OPERATION
Your enclosure comes from the factory with the
door safety lock 'LOCKED'. To unlock, move the
center lock up to the unlocked position (as shown in
FIGURE 8).
To OPEN the door, slide and keep holding top latch
in pulled-back position. Lift door up and over
threshold, then open out (as shown in FIGURE 9).
To CLOSE the door, slide and keep holding top latch
in pulled-back position. Lift door up over threshold.
Engage door in frame catch as shown in FIGURE 10.
Set door down in threshold and release latch.
TO LOCK the door, move center lock down to locked
position once child is secure.
TO DISCONNECT PANELS
To disconnect two adjoining panels, select one of the
joints where the panel pushes down (panel 1), as
shown in FIGURE 11.
Gently press down on panel 1 while lifting slightly on
panel 2. This will enable you to slide pin "C" free of
cylinder "D" (see FIGURE 5). Then lift up on panel 1
until opening "A" (see FIGURE 4) is free of pin "B".
FOLDING FOR TRANSPORT OR STORAGE
Your enclosure folds compactly for transport or storage. You must,
however, fold the panels properly. Disassembly and folding is
accomplished by first following the "DISCONNECT PANELS"
instructions above.
Gently fold the panels (without jerking them or slamming them
together) in alternating directions like an accordion. FIGURE 12
illustrates the configuration of a properly folded yard.
Slip one end of the gray carrying strap through the mesh near the
top middle of each outside panel and snap it closed. The enclosure
is now ready for transport or storage.
CLEANING INSTRUCTIONS
Your enclosure is manufactured from durable, weather-resistant plastic panels. To clean, wash the
panels with mild, non-abrasive detergent, rinse with clean water, and allow to dry thoroughly.
REPLACING A PANEL
A broken panel can easily be replaced by obtaining one from the manufacturer at
www.northstatesind.com
Remove the broken panel by following the "TO DISCONNECT PANELS" instructions (above).
Install the replacement panel by following the "SET-UP INSTRUCTIONS" (page 3).
FIGURE 8
FIGURE 10
Frame
Catch
FIGURE 11
PANEL 1
Opening A
FIGURE 12
FIGURE 9
Page 4
FIGURE 9
D
Pin C
PANEL 2
Pin B
Publicidad
Tabla de contenido
