Whirlpool AMD 098/1 Instrucciones Para El Uso página 25

MAINTENANCE
Draining the Air Conditioner
(in accordance with the indication of Water Full
under "Starting your local air conditioner".)
1. Press ON/OFF to turn off the air conditioner.
2. Unplug air conditioner or disconnect power.
3. Move the appliance gently and stably to a
draining location or outside to drain water. Do not
move the unit before water is drained out
completely.
4. Remove the secondary drain plug and drain
water completely.
5. Remove the primary drain hose from the drain
hose clip. Remove the drain hose plug from the
end of the primary drain hose and drain water
completely.
NOTE: If air conditioner will be stored after use,
see "Storing After Use."
6. Reinstall the drain hose plug and the secondary
drain plug.
7. Reattach the primary drain hose to the drain
hose clip.
8. Reposition the air conditioner.
9. Plug in air conditioner or reconnect power.
10. Press ON/OFF to start the air conditioner.
Cleaning the Air Filter
1. Press ON/OFF to turn off the air conditioner.
2. Open the filter panel door on the back of the air
conditioner and remove it.
3. Remove the air filter from the filter panel door.
4. Use a vacuum cleaner to clean the filter. If filter
is very dirty, wash filter in warm water with a mild
detergent.
NOTE: Do not wash filter in the dishwasher or
use any chemical cleaners.
5. Air dry filter completely before replacing to
ensure maximum efficiency.
6. Reattach the air filter to the filter panel door.
7. Reinstall filter panel door.
8. Press ON/OFF to start the air conditioner.
Cleaning the Outside
1. Unplug air conditioner or disconnect from
power.
2. Remove the air filter and clean separately. See
"Cleaning the Air Filter."
3. Wipe outside of the air conditioner with a soft,
damp cloth.
4. Plug in air conditioner or reconnect power.
5. Press ON/OFF to start the air conditioner.
A. Secondary drain plug
B. Drain hose plug
C. Drain hose clip
D. Primary drain hose
A. Filter panel door
B. Air filter
Storing After Use
1. Drain the water (see the "Draining the Air
Conditioner")
2. Run the air conditioner set to Fan Only for
approximately 12 hours to dry the air conditioner.
3. Unplug air conditioner.
4. Remove flexible exhaust hose and store with air
conditioner in a clean, dry area. See "Installation
Instructions."
5. Remove window kit and store with air
conditioner in a clean, dry area. See "Installation
Instructions."
6. Remove the filter and clean. See "Cleaning the
Air Filter."
7. Clean the outside of air conditioner. See
"Cleaning the Outside."
8. Reinstall filter.
9. Remove the batteries and store the remote
control with air conditioner in a clean, dry area.
25