Testing Network Connection - Tripp-Lite PDUMH15AT El Manual Del Propietario

3. Installation
You can also change the root password, real-time clock and other settings. (Tripp Lite
recommends against changing the default settings unless you are an advanced user with a
specific purpose.) After you have finished entering settings, the PDU will save changes to
memory and reboot (this may take several minutes). After the PDU reboots, the initialization
page should display the new static IP settings.
3.5F
Remove Serial Cable: Remove the serial cable from the PDU and proceed to Step

3.6 Testing Network Connection

3.6A
Access PDU with Web
Browser: After an IP address has been
assigned to the PDU, attempt to access it
with a Web browser that supports frames,
forms and Java ™
computer connected to the LAN and enter
the IP address assigned to the PDU. You
should be prompted for a password
user name is admin and the default
password is admin. After you enter the user
name and password, the PowerAlert Status
page will appear in the browser window.
B
For more information about configuration
and operation of the PDU via the PowerAlert
interface, refer to the SNMPWEBCARD
User's Guide, included on the CD-ROM
bundled with the PDU.
Note for Network Management System Users
Only: Two MIB files - Tripplite.mib and RFC1628.
mib - must be loaded on each Network
Management Station that will monitor the PDU via
SNMP . The files are provided on the CD-ROM
included in the product package.
21-02-124 933E0A.indb 10 21-02-124 933E0A.indb 10
(continued)
. Open a Web browser on a
. The
A
A
B
10
.
3.6A
3/25/2021 2:19:09 PM 3/25/2021 2:19:09 PM