Grinding Belts; Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL TC-MG 135 E Manual De Instrucciones Original

7.7. Accessories (Fig. 13a/b / Fig. 1; Item 5/11)
1 Clamping sleeve 0.6-3.2 mm
2 Cutter
7.8. Accessories (Fig. 14 / Fig. 1;
Item 2/4/ 6/10)
1 Arbor for felt wheels
2 Arbor for grinding wheels
3 Felt polishing wheel
4 Felt polishing wheel
5 Grinding wheel
7.9. Accessories (Fig. 15 / Fig. 1; Item 7)
1-6 Drill bits (1-3 mm)
7.10. Description of the accessories:
Cutting disks:
For cutting metal and plastic.
Insert the cutting wheel onto the clamping spind-
le.
Grinding pins:
In various grinding head shapes.
For grinding and deburring metal and plastic.
HSS bits:
For drilling work on non-ferrous metals, wood,
plastic and printed circuit-boards.
Grinding wheels:
For cleaning and sharpening blades and tools. In-
sert the grinding wheel onto the clamping spindle.
Polishing wheels / polishing pins:
For polishing brass, tin, copper, etc. Also for use
with polishing pastes.
Pot brushes:
For cleaning stone, metal, aluminium, etc.

Grinding belts:

For grinding word and plastic.
Diamond cutting wheel:
For cutting, separating, grinding and deburring
materials, such as concrete, stone, china, cera-
mic, etc.
Sleeves:
Various sizes for mounting diff erent accessory
tools.
Anl_TC_MG_135_E_SPK9.indb 19 Anl_TC_MG_135_E_SPK9.indb 19
GB
Cutters:
For cutting plastic, wood and soft metal
Collet chuck key
For mounting accessory tools

8. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
9. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
9.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
9.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualifi ed electrician.
Danger! The carbon brushes should not be rep
laced by anyone but a qualifi ed electrician.
9.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
- 19 -
28.09.2021 16:14:02 28.09.2021 16:14:02