WMF Impulse Indicaciones De Uso Y Cuidado página 4

WMF Insulation jugs
No matter whether you're at home or at a mee-
ting in the office – a cup of hot tea or coffee
improves your concentration and gives you fresh
inspiration. The Impulse insulation jugs are a
clear statement for stylish design and impress
with just how well they keep drinks insulated.
After 12 hours your tea or coffee still has a
pleasant temperature for drinking of 70°C.
Quality features
ThermaPro - outstanding insulating
performance for up to 24 hours.
Double effect: thermal liner made of double-
walled hard glass. The vacuum between the glass
bodies reduces the loss of warmth. The insulating
glass is mirrored in the vacuum, the radiation
heat is reflected and the insulating performance
is improved.
Casing made from Cromargan®: stainless steel
18/10 or high-quality plastic.
With automatic or twist closure.
Easy to clean and hard-wearing when the fol-
lowing instructions are observed.
Please read the following instructions for use
and care completely before using this product
for the first time.
4
EN
Usage instructions
Rinse the jug with lukewarm water before using
it for the first time and leave the jug to dry out
thoroughly.
Check the base is securely tightened on a regular
basis. If it has come loose, twist the screws in
a clockwise direction with a large coin until it
goes tight again. This ensures that the casing and
thermal liner will remain tight.
To optimise the insulating performance and to
stop the glass from breaking, rinse the jug with
either hot or cold water before use.
Never pre-heat the jug in the microwave, oven or
on a hot plate.
Fill the jug up to no higher than about 2 cm un-
derneath the pouring stopper, never fill it
up completely.
Insulation jug with automatic closure:
To pour out of the jug just press the stainless
steel button downwards, and to seal the jug press
it again. Drip-free pouring is only possible if the
lid marking is at the height of the handle; twist
the lid tightly to close it. To undo the lid, twist
it anti-clockwise and pull upwards.
Thermal jugs with a screw-top lid:
To pour, twist the lid half a turn anti-clockwise
until the marking is aligned with the spout. This
is the only way to ensure drip-free pouring.